"How to Fix a Rocking Toilet"
Ever found yourself doing a balancing act while using the restroom? A rocking toilet can be an annoyance, but don't let it get you down. There are a few simple ways to fix this common problem, and we're here to guide you through them. Let's dive right in.
First, let's understand what causes a toilet to rock. Most often, it's due to amovement in the floor underneath the toilet, such as when the floor joists are not properly supported. Whatever the reason, it's essential to fix it to avoid potential hazards and ensure your comfort.
Identifying the Cause
The first step in fixing your rocking toilet is to identify the cause. Grab a piece of chalk and trace around the base of your toilet.
Now, take a look at the chalk line. If it's not completely straight, the underlying issue is likely a uneven floor. Another common cause is a wonky toilet flange, so make sure to check that as well.
Uneven Floor
If your floor is uneven, you might need to shim the toilet to level it out. Here's how:
First, buy some tapered plastic shims and cut them to match the height of the low spot. Then, place the shims under the feet of the toilet. Tighten the bolts and ensure the toilet is level using a spirit level. Finally, test the toilet by gently sitting and standing to ensure it's stable.
Wonky Toilet Flange
If the toilet flange is at fault, you'll need to adjust it. Here's a simple way to do it:
Turn off the water supply to the toilet and flush to empty the tank. Disassemble the toilet and remove the old wax ring. Straighten the flange if it's bent, then replace the wax ring. Reassemble the toilet and tighten the bolts until they're snug.
Additional Solutions
If the above solutions don't work, there might be other underlying issues.
For example, the toilet bolts might be loose or stripped, or the floor underneath the toilet might be rotting. In these cases, you might need to replace the bolts or the floor entirely.
Loose or Stripped Bolts
If your bolts are stripped, use a mending plate to secure the toilet to the floor. Here's how:
First, remove the old bolts and spacers. Then, attach the mending plate to the underside of the toilet. Drill new holes where the plate's bolts will go, and attach the plate. Finally, reinstall the bolts and tighten them.
Rotten Floor
If your floor is rotting, you'll need to replace it. This might seem like a daunting task, but it's not as difficult as it sounds.
First, turn off the water supply and remove the toilet. Cut out the rotting section of the floor, then install a new piece of plywood. Reinforce the new floor with support beams if necessary, then reinstall the toilet.
Remember, if you're unsure about any of these procedures, don't hesitate to call a professional plumber. It's always better to be safe than sorry. Your comfort and safety should always be your top priority. Happy fixing!