Drain Kenmore Washer: Step-by-Step Guide
If your Kenmore washer is causing you grief, it might be time to drain it and perform some troubleshooting or maintenance. Here's a step-by-step guide to help you drain your Kenmore washer safely and effectively.
Before we start, ensure you have the following tools and materials: a bucket, a screwdriver, a flathead tool, and possibly a wrench, depending on your model.
Preparation and Safety Measures
Before you begin, make sure to turn off and unplug your washer to prevent any electrical accidents. Also, lay down a towel or place a bucket under the drain hose to collect any excess water that may leak out.
Next, remove any loose items from the washer, such as lint from the lint trap or Debris from the drain pump.
Locating the Drain and Overfill Hoses
The drain hose is usually connected to the back of the washer and runs down to the drain. The overfill hose might be connected to the washing machine as well, depending on your model and plumbing configuration.
Inspect both hoses and ensure they're securely connected to their respective couplings and not clogged with debris or kinked.
Understanding the Water Drain Process
Kenmore washers use a drain pump to remove water from the tub. Some models also have a drain valve that can be manually opened. Consult your user manual to identify which components your washer has.
In many cases, stopping the washer mid-cycle will cause the drain pump to expel the remaining water automatically. If this doesn't work or your washer doesn't have a drain pump, you'll have to manually drain the water.
Draining the Kenmore Washer
If your washer has a drain pump, you can try to drain the water by stopping it mid-cycle. Here's how:
1. Open the washer door and pause the cycle.
2. Check if the water level is above the drain hose. If so, some models will automatically begin draining. If not, you may need to wait for a bit until water reaches the drain pump.
Manual Drain Method (For Washers Without a Drain Pump)
If your Kenmore washer doesn't have a drain pump, or if the above method doesn't work, you'll need to manually drain it. Here's how:
1. Access the drain valve or the manual drain syringe, depending on your model. The manual drain is usually located at the bottom front of the washer, while the drain valve might be under a panel at the bottom rear.
2. For the manual drain method: Using a flathead tool, unscrew the cap on the manual drain. Water should start pouring out. If it doesn't, gently pull out the drain syringe and squeeze it to help the water flow.
Draining the Drain Pump
Sometimes, the drain pump itself might be clogged with lint, debris, or a squeegee rope. If you suspect this is the case, you can drain the pump and clean it. Here's how:
1. Find the drain pump, usually located at the bottom rear of the washer. You might need to remove a panel to access it.
2. Using a screwdriver, loosen and remove the clamp securing the drain hose. Disconnect the hose from the pump.
3. Place a bucket underneath the hose, then squeeze or manipulate the drain pump to expel any trapped water. Check for, and remove, any obstructions in the pump.
Once you've drained your Kenmore washer, it's a good idea to check the key components again, especially the drain hose and the drain pump, to make sure they're functioning correctly. If not, you may need to seek professional repair services.