how to drain irrigation system for winter

Winterize Your Irrigation System: How to Drain for Cold Seasons

By Thomas Hernandez
AD

Winter's approach signals the end of the gardening season and the need to prepare your irrigation system for the cold months ahead. Draining your irrigation system for winter is a crucial step to prevent costly repairs and ensure its longevity. This comprehensive guide will walk you through the process, ensuring your system is ready to face the frost and eager to resume service in the spring.

Before you begin, gather your tools: a screwdriver, adjustable wrench, and a key for your system's backflow preventer, if applicable. Also, check if your system is equipped with an automatic drain or blow-out system. Fully understanding your system ahead of time will simplify the winterizing process.

Manual Draining

Manual draining is suitable for low-pressure systems, typically found in homes with just a few zones. It's a simple, cost-effective method that doesn't require special equipment.

AD
how to winterize your sprinkler system
how to winterize your sprinkler system
Drip Irrigation Winter Care
Drip Irrigation Winter Care
Winterizing Your Drip Irrigation System
Winterizing Your Drip Irrigation System

Here's how to do it:

Step 1: Turn Off the System

Ensure your irrigation controller is set to 'Off' for the season. Shut off the main water supply valve, usually located near yourGot the system's backflow preventer.

5 Steps to Prepare Your Yard for Winter
5 Steps to Prepare Your Yard for Winter
2. Winterize your irrigation system #MonthlyLawnTip
2. Winterize your irrigation system #MonthlyLawnTip

Step 2: Open Manual Drain Valves

If your system has manual drain valves at the lowest points, open them to allow water to drain from the pipes. You should hear the water draining; if not, check for obstructions or leaks.

Step 3: Drain the Backflow Preventer

Using a screwdriver, loosen the port caps on your backflow preventer. This allows water to drain from the unit. If your backflow preventer has a device called a 'bleeder valve,' open it to release any remaining water.

AD

Automatic Drain or Blow-out Systems

High-pressure systems, usually found in commercial properties, utilize automatic drain or blow-out systems. These systems use air pressure to force water out of the pipes.

Here's how to drain your system using these methods:

Automatic Drain Valve

Turn off the main water supply and disconnect the water supply line. The automatic drain valve will then drain the remaining water from the system's pipes.

AD

Blow-out Systems

Blow-out systems require an air compressor. Turn off the main water supply and connect the air compressor to the blow-out port. Slowly introduce air into the system, starting with the lowest zones. Monitor the process to ensure all water is forced out of the lines.

Additional Winterizing Steps

After draining your system, take these additional steps to ensure its winter readiness:

Inspect Your System

Visually inspect your system for any leaks, cracks, or other damage. Repair any issues now to prevent bigger problems in the spring.

AD

Insulate Sensitive Components

Use foam insulation or heat tape to protect backflow preventers, shut-off valves, and other sensitive components from freezing temperatures.

Winterizing your irrigation system might seem daunting, but following these steps ensures your system will survive the cold months and be ready to resume service in the spring. Regular maintenance not only prolongs the life of your system but also saves you money in the long run. So, roll up your sleeves, grab your tools, and get ready to give your irrigation system a well-deserved winter break.

AD