How to Drain an Inground Pool Below Skimmer
Draining an inground pool below the skimmer is a crucial maintenance task that ensures your pool's longevity and safety. When done correctly, it helps prevent damage from freezing temperatures, algae growth, and skimmer damage. This comprehensive guide will walk you through the process, step by step, ensuring a professional finish.
Before proceeding, ensure you have the necessary tools: a garden hose, a submersible pump, a long hose, estudiolino (drain plug tool), and safety equipment like gloves and goggles.
Understanding Pool Drainage
Inground pools typically have three main drainage points: the skimmer, the main drain, and the cleaner line. Draining your pool below the skimmer requires removing water from these points until the water level is well below the skimmer's mouth.
This process is not as simple as plugging a bathtub. Pools have intricate plumbing systems, and improper draining can lead to structural damage, skimmer erosion, or even a collapsed pool. Always ensure you follow safety guidelines and understand your pool's design before proceeding.
Determining the Drain Level
First, calculate the water level you need to reach. Most skimmers are about 18 inches above the pool floor. To drain the pool below the skimmer, you'll need to lower the water level to at least 24 inches below the skimmer mouth.
Measure the distance from the top of the skimmer to the water level, then subtract 24 inches to determine how much water you need to remove.
Preparing the Equipment
Check your submersible pump and make sure it's in good working order. Attach a long enough hose to reach the lowest point in your pool. This will usually be near the main drain or the deepest end.
Clear any debris from the pool floor to prevent clogging the pump. Also, ensure the pump is compatible with your pool's size. A pump with too high a flow rate can affect the pool's structural integrity, while one that's too low won't drain the pool effectively.
Draining the Pool
Begin by setting up your pump and hose. Place the pump in the deepest part of the pool and run the hose to a location where the water can safely be discharged, generally a few feet away from the pool's edge.
Before switching on the pump, ensure it's securely placed and won't move around while operating. Also, keep the intake open to avoid drawing in debris that could clog the pump.
Teilnehmer the Drainage Process
Start the pump and let it run for a few minutes to remove the pool's surface water. This will help expose the lower levels of the skimmer and help you monitor the water level more accurately.
Every few hours, stop the pump, remove the hose, and use your estudiolino to loosen and remove the drain plugs in the pool's main drain and cleaner line. This allows water to drain from these points as well, evening out the water level.
Monitoring the Drainage Process
Regularly check on the pump and ensure it's working properly. If the water slows down or stops flowing, there may be a clog or air in the system. Switch off the pump and check for any blockages.
Also, monitor the water level and the surrounding area for signs of changes. If the pool walls or floor start to shift or bulge, turn off the pump immediately. These could be signs of structural stress or damage.
Finishing Up
Once the water level is below the skimmer, turn off the pump and remove it from the pool. Allow the remaining water to drain naturally. This may take a few days, depending on how flat the surrounding area is.
After the pool is completely drained, inspect the interior for any signs of damage. Touch up any patches or repairs as needed, and clean the pool thoroughly before refilling.
Draining an inground pool below the skimmer might seem daunting at first, but with careful planning and execution, it's a manageable task. Always remember to prioritize safety and understand your pool's unique design. Professional help may be necessary for complex or large-scale pool draining jobs.