how to drain a washer
So, your GE washer is giving you trouble, huh? Don't worry, it's a common predicament and there's a quick fix for it. Draining a GE washer isn't as complicated as it sounds, and with a few simple steps, you'll have your laundry routine back on track in no time. Let's dive into the process and learn how to drain a GE washer like a pro.
Before we start, it's important to note that this guide applies to front-loading and top-loading GE washers. Now, grab your tools - a screwdriver, a bucket, and some towels - and let's get started!
Identify the Drain Hose
Before you start, you need to find where the drain hose is located. For top-loading washers, it's usually at the back of the machine. For front-loaders, it's typically at the bottom, behind the unit. See, I told you it was simple!
Preparation: Gather Your Tools
Here's what you'll need for the job:
- A screwdriver (usually a Phillips or flathead)
- A bucket or large bowl
- Some old towels or rags
Safety First: Unplug the Washer
First things first, safety! Always unplug your washer from the power source before you start working on it. No sense in-taking any unnecessary risks, right?
Next, turn off the water supply valves - they're usually located behind the washer. If you can't reach them, don't worry, you can drain the washer without disconnecting them.
Draining the Washer
Now that everything's set up, it's time to drain that washer. Let's get our hands dirty!
First, locate the drain hose. If it's connected to a standpipe, disconnect it. If it's not, ignore this step. Then, place your bucket or bowl underneath the hose to catch any water that drips out. If you have a front-loader, you might need to tilt the drain hose up to let the water out.
Drain the Pump Assembly (Top-Loaders)
For top-loading washers, there's an extra step. You'll need to drain the pump assembly. Located at the bottom of the washer, it's the source of all the water in your washer. Grab your screwdriver and remove the access panel - it's usually held in place by a few screws.
Check the Drain Pump (Top-Loaders)
Once you've removed the access panel, you'll see the drain pump. Check it for any blockages - it might be full of debris or lint. If it is, clean it out. If it's not blocked, replace the access panel and proceed.
Refill the Washer
Congratulations! You've successfully drained your GE washer. But wait, we're not quite done yet. Before you can use your washer again, you need to refill it with water.
Reconnect the drain hose, making sure it's securely attached and not kinked. Then, reconnect the power cord and turn on the water supply valves. Run a rinse cycle to fill the washer with clean water.
Inspect the Drain Hose and Standpipe
While the washer is filling, take a peek at the drain hose and standpipe. Make sure water is flowing freely, and there are no signs of leaks. If everything looks good, you're all set!