Step-by-Step Guide: Change Samsung Refrigerator Water Filter
Are you experiencing a funny taste or weak water pressure from your Samsung fridge's water dispenser? It might be due for a filter change. Here's a comprehensive guide on how to change your Samsung fridge water filter, ensuring you enjoy fresh and clean water at all times.
Before we begin, make sure you have the following on hand: the new Samsung Genuine Water Filter ( Sites and Dates of manufacture (mfd. date) vary by model, so ensure you purchase the correct one for your fridge ), a bowl or container to catch any water, and a filter wrench tool (often included with the new filter or can be purchased separately).
Preparing Your Samsung Fridge for Filter Replacement
Before you start, turn off the ice maker and water dispenser in the refrigerator to prevent any leaks. Then, remove any remaining ice from the ice tray and discard it.
Next, locate the water filter. For most Samsung fridges, it's usually found behind an access panel at the bottom of the fresh food compartment or in the back of the fresh food compartment, behind a cover. Consult your user manual for the exact location of your filter.
Turning Off the Water Supply
To minimize spills, turn off the water supply to the refrigerator. This is usually a valve located under the sink, behind the fridge, or near the plumbing line to the fridge.
Once the water supply is off, open the refrigerator door and turn the water dispenser on to release any remaining water pressure. Allow any excess water to drain from the dispenser and into a container.
Accessing the Water Filter
For filters located behind an access panel at the bottom of the fresh food compartment, pull out the panel by lifting up on the bottom edge until it slides out. For filters located in the back of the fresh food compartment, remove the cover as indicated in your manual.
If your filter is located in the back, you may need to remove any shelves or drawers blocking the filter to access it.
Removing the Old Water Filter
if your old water filter has an electronic indicator (present on certain Samsung models), press the "Reset" button on the display before proceeding. This will reset the indicator light.
Next, twist the cap on the old filter counter-clockwise to loosen it. Once loosened, use your hands to turn the filter in a counter-clockwise direction. You may need to use the filter wrench tool to help you grip the filter. Continue turning until the old filter is fully removed from the housing.
Preparing the New Water Filter
Remove the new water filter from its packaging and attach the filter cap onto the filter by screw it on clockwise. Do not overtighten as this can damage the O-ring and cause leaks.
Check the filter's manifold (the part with the inlets and outlets) to ensure it's pointing towards the back of the refrigerator. It should fit into the housing without needing to be forced or twisted.
Installing the New Water Filter
With the water valve turned off, slowly screw the new filter into the housing by turning it clockwise. You may need to use the filter wrench tool to apply sufficient torque. Continue turning until the filter is fully seated and the cap is flush with the housing.
If your new filter has an electronic indicator, press the "Replace" button on the display to register the new filter.
Priming the New Water Filter
Slowly turn the water valve back on and allow water to run through the dispenser for about 5 minutes or as recommended in your user manual. This helps prime the new filter and remove any charcoal dust or air from the new filter.
If your filter has an electronic indicator, once it's primed, it should display "Replace Soon" or similar message indicating the new life cycle of the filter. Keep track of this date to ensure you change the filter on time.
Great job! You've just successfully changed your Samsung fridge water filter. Remember to replace the filter every 6 months or 300 gallons, whichever comes first, to ensure your water stays fresh and clean. Happy refreshed drinks!