Easy Steps to Change Pedals on Peloton Bike
Elevate your indoor cycling experience by customizing your Peloton bike's pedals. Changing pedals allows you to use cycling shoes with Look Delta or SPD cleats, enhancing your comfort, stability, and overall workout. Here's a step-by-step guide on how to change pedals on your Peloton bike.
Before you begin, ensure you have the new pedals and the appropriate tools at hand. For Look Delta pedals, you'll need a 15mm pedal wrench, while SPD pedals use a standard 8mm pedal wrench. Additionally, have a 4mm Allen wrench ready for adjusting cleat position.
Removing the Old Pedals
Start by removing your Peloton's old pedals. For Look Delta pedals, use the 15mm pedal wrench to loosen and remove the pedal by turning it counterclockwise. If you're replacing SPD pedals, use the 8mm pedal wrench instead.
Be cautious not to lose the unique metal washer that sits between the pedal and the crank arm, as it plays a vital role in maintaining proper pedal rotation. Keep the original pedals in case you want to revert to them later.
Identifying the Left and Right Pedals
To avoid mixing up the left and right pedals, note the marks on each pedal when removing them. The left pedal has a left-facing thread, while the right pedal has a right-facing thread. Alternatively, mark both pedals with a pen before unscrewing them.
When attaching the new pedals, ensure you align the taller part of the cleat with the line on the pedal, so it sits flush with the pedal's surface. This orientation provides the best support and stability for your feet.
Preparing the New Pedals
Before installing the new pedals, ensure they're compatible with your cleats. Most Peloton bikes use either Look Delta or SPD cleats, but double-check to avoid any compatibility issues.new pedals often come with grease to reduce friction and facilitate smooth rotation. Apply a small amount on the pedal's bore and threads.
Next, install the metal washer on the pedal's thread, if required. This washer helps maintain proper pedal alignment and prevents excessive wobbling. Your new pedals may not require it, so always check the manufacturer's instructions before proceeding.
Installing the New Pedals
Begin by installing the left pedal first. Screw it onto the crank arm using even, counterclockwise pressure. Be careful not to cross-thread the pedal, which can cause damage and make removal difficult. Continue screwing until the pedal hits the crank arm, stopping when it's about 1-2 cm from being fully tight.
Now, install the right pedal with a similar process. Again, be cautious to avoid cross-threading, screwing until it's about 1-2 cm from being fully tight.
Tightening the Pedals
After both pedals are securely screwed onto the crank arms, it's time to tighten them firmly. For Look Delta pedals, use the 15mm pedal wrench and apply even, clockwise pressure until the pedal is snug but not excessively tight. Be careful not to overtighten, as this can strip the pedal's threads or damage the crank arm.
For SPD pedals, use the 8mm pedal wrench and apply similar pressure. Remember to alternate between left and right pedals to ensure even tension and prevent over-tightening.
Adjusting Cleat Position
After tightening the pedals, the final step is to adjust your cleats' fore and aft position to ensure optimal comfort and efficiency. Use a 4mm Allen wrench to loosen the cleat's mounting screw, and slide the cleat forward or backward as needed. The general recommendation is to position the cleat's ball with the arch of your foot.
Once you've found the perfect position, re-tighten the cleat's mounting screw, and you're ready to clip in and enjoy your customized Peloton bike experience!
Regularly inspect your new pedals before each ride to ensure they're properly tightened and functioning correctly. Happy cycling, and embrace the challenge of pushing your limits on your enhanced Peloton bike!