how to change outer tie rod

How to Change an Outer Tie Rod: Step-by-Step Guide

By Daniel Lee
AD

You can ensure your vehicle's steering and safety by regularly inspecting and replacing worn-out parts, such as the outer tie rod. This integral component connects the steering gear or rack to the front wheel, allowing your vehicle to change directions. This guide will walk you through the steps to change your outer tie rod, step by step.

Before you embark on this DIY project, ensure you have the necessary tools, including a jack and jack stands, metric wrench set, new tie rod, tie rod end tool, and a torque wrench. Always remember to park on a level surface and use wheel chocks for safety. This article assumes you're working on a vehicle with standard right-hand drive configuration.

Preparation and Removing the Old Tie Rod

The first step involves preparing your vehicle and removing the old outer tie rod. Jack up the front of your vehicle and secure it with jack stands for stability. Use a metric wrench set to loosen and remove the tie rod nut, located on the tie rod's inner side. Make sure to keep track of any wechsel Elementary (WE) marks, as they aid in reassembling the tie rod andări nut correctly.

AD
How to Change Tie Rods (inner and outer tie rod ends)
How to Change Tie Rods (inner and outer tie rod ends)
How to Replace an Outer Tie Rod End
How to Replace an Outer Tie Rod End
How To Replace an Outer Tie Rod End
How To Replace an Outer Tie Rod End

Using the tie rod end tool, carefully pry off the tie rod end. Rotate the tool while pulling it away from the tie rod end. Continue this process until the tie rod end is separated from the steering arm. Now, you can remove the old tie rod carefully, as it might still be attached to the outer tie rod housing.

Inspecting and Preparing the Steering Components

Before you proceed, ensure the tie rod andări nut's threads are free of dirt and corrosion. Apply a suitable grease to the threads for smoother installation and easier maintenance later on.

Installing the New Outer Tie Rod

Slide the new outer tie rod into position, ensuring the splines on the tie rod end align with those on the steering arm. Temporarily install the new tie rod end using the tie rod end tool, then slip on the tie rod nut. Thread the nut onto the tie rod end, but don't fully tighten it yet.

Install the new outer tie rod end back onto the front wheel's steering arm. Ensure the WE marks align for proper angularity, and torque the tie rod nut. Use a torque wrench set to 25-30 ft-lbs (depending on your vehicle's specific requirements) while holding the tie rod end steady with a wrench. This precaution prevents the tie rod end from spinning.

Adjusting and Finishing the Job

Once the tie rod nut is torqued, lower your vehicle from the jack stands. Locate the tie rod adjustment screw, usually found near the inner tie rod. Use a wrench to turn the adjustment screw clockwise or counterclockwise to fine-tune the vehicle's alignment, as needed. Be sure to follow your vehicle's specific adjustment procedures for accurate results.

Before you hit the road, take your vehicle for a test drive to ensure the steering is centered and feels normal. Be prepared to make further alignments if necessary. Properly maintaining your vehicle's outer tie rod is essential for safe handling, responsive steering, and extending the life of other suspension components. Regularly inspect your vehicle's tie rods and perform the necessary replacements to keep it running smoothly.

You're all set! By following this guide, you've successfully learned how to change the outer tie rod on your vehicle. The next time you notice your vehicle's steering is off, or you hear unusual noises, don't hesitate to check and replace the outer tie rod. Happy DIYing, and until next time!

a man is working on the front wheel of a car with a measuring tape around it
a man is working on the front wheel of a car with a measuring tape around it
How to Change Inner and Outer Tie Rods - Track Rods (Saturn Vue)
How to Change Inner and Outer Tie Rods - Track Rods (Saturn Vue)
AD