how to change oil on a jet ski

Step-by-Step: How to Change Oil on a Jet Ski

By Amanda Clark
AD

Regular maintenance is essential to keep your jet ski running smoothly and safely. One of the most important tasks is changing the oil, which should be done every 50 to 100 hours of operation, or annually, depending on the manufacturer's recommendations. This guide will walk you through the process in simple, step-by-step instructions.

Before you begin, ensure you have the necessary equipment and materials, including gloves, an oil filter, 20W-50 or 15W-50 marine oil (consult your owner's manual for the exact type), a 5mm Allen wrench, an oil catch pan, and new crush washers.

Preparation and Draining

First, make sure your jet ski is on a trailer or stable boat lift. This will allow you to work underneath it safely. Next, disconnect the negative battery cable to prevent any electrical shorts.

AD
two men are working on an engine in a car shop, one is pouring something into the other
two men are working on an engine in a car shop, one is pouring something into the other
Oil Change & RIVA Racing SCOM Install on a 2018 Sea-Doo RXT-X 300: The Watercraft Journal Ep. 42
Oil Change & RIVA Racing SCOM Install on a 2018 Sea-Doo RXT-X 300: The Watercraft Journal Ep. 42
the inside of an orange motorcycle with its engine and parts labeled in red on it
the inside of an orange motorcycle with its engine and parts labeled in red on it

Locate the oil pan and oil filter on the bottom of the engine. In most jet skis, these are positioned near the PDI panel. Use your 5mm Allen wrench to loosen the oil pan drain plug by turning it counterclockwise. Have your oil catch pan ready to catch the oil. Once the plug is loose, remove it by hand and allow the oil to drain completely.

Removing the Oil Pan

Now that the oil has drained, remove the oil pan. It's usually held on by 8 or 10 bolts. Using your 5mm Allen wrench, remove these bolts and gently pry the oil pan away from the engine. You may need to use a rubber mallet or a screwdriver with a flat end to help loosen it.

Jet Ski Ultra Oil Change
Jet Ski Ultra Oil Change
How to Winterize Sea-doo GTI SE 130 Jet Ski to Save Money DIY - Not Sealed
How to Winterize Sea-doo GTI SE 130 Jet Ski to Save Money DIY - Not Sealed

Inspect the oil pan and gasket for any damage or wear. If necessary, replace the gasket with a new one to ensure a proper seal.

Installing the New Oil Pan and Filter

Before reinstalling the oil pan, apply a small amount of new oil to the new gasket. This will help create a better seal and make it easier to remove during future oil changes. Reposition the oil pan on the engine and secure it with the bolts, ensuring they are fully tightened.

AD

Install the new oil filter by screwing it onto the filter mount, turning it clockwise. Be careful not to overtighten, as this can damage the filter. Once in place, pour the recommended amount of oil into the upper oil fill hole. This is usually between 0.8L to 1.3L, but check your owner's manual for exact measurements.

Checking and Topping Off the Oil

After adding the oil, allow it to settle for a few minutes before checking the oil level with the dipstick. Remove the dipstick, clean it with a lint-free cloth, and reinsert it. Pull it out again and check the level. It should be at the 'FULL' mark for most jet skis.

If the oil level is low, top it off with the appropriate marine oil. Always check your oil level after running your jet ski for a few minutes, as it may settle a bit. Be sure to clean up any oil spills to prevent environmental contamination.

AD

Replacing the Drain Plug

Before replacing the oil pan drain plug, examine the crush washer. If it's dramatically deformed, replace it with a new one to ensure the best seal. Reinstall the drain plug by hand, then use the 5mm Allen wrench to tighten it. Tighten it snugly, but not too much – your goal is to create a seal, not crush the washer.

Once the drain plug is secure, reconnect the negative battery cable and you're ready to ride. Remember, regular oil changes are crucial for your jet ski's engine health and longevity. It's a good practice to check your oil level every time you use your jet ski, and top off as necessary.

Embracing regular maintenance and understanding your jet ski's specific needs will ensure countless hours of fun on the water. Now that you know how to change the oil on a jet ski, you can keep your engine running smoothly and safely. Happy riding!

AD
AD