how to change oil briggs and stratton lawn mower

How to Change Oil Briggs & Stratton Lawn Mower

By Thomas Davis
AD

Regular oil changes are vital to maintain the longevity and efficiency of your Briggs & Stratton lawn mower. Engine oil lubricates the moving parts, reduces friction, and prevents wear and tear.This article will guide you through a step-by-step process on how to change the oil in your Briggs & Stratton lawn mower safely and effectively.

Before starting, ensure your mower is on a flat surface and has cooled down to prevent any burns. Also, gather your tools - an oil funnel, a socket wrench, a catch pan for the old oil, and the correct lightweight SAE 10W-30 or 5W-30 engine oil. Briggs & Stratton recommends using their branded oil to maintain your engine's warranty.

Draining the Old Oil

Start by locating the oil pan under your Briggs & Stratton lawn mower. It's typically found on the bottom of the engine.

AD
How to Drain Excess Oil From Lawn Mower | Describe in 4 Steps (2026)
How to Drain Excess Oil From Lawn Mower | Describe in 4 Steps (2026)
Mtd 20 inch lawn mower carburetor repair briggs and stratton 300e carb cleaning Results at the end!
Mtd 20 inch lawn mower carburetor repair briggs and stratton 300e carb cleaning Results at the end!
a lawn mower with the words how to clean lawn mower carburetor without removing it
a lawn mower with the words how to clean lawn mower carburetor without removing it

Next, use a socket wrench to loosen and pull out the oil pan's drain plug. Be sure to keep it handy, as you'll need it later to close the oil pan.

Replacing the Oil Filter

While the old oil is draining, locate and remove the oil filter. It's usually situated at the bottom or on the side of the engine, attached to the oil pan.

How To Fix the MOST COMMON problem on MOST COMMON Lawnmower Briggs and Stratton engine wont start
How To Fix the MOST COMMON problem on MOST COMMON Lawnmower Briggs and Stratton engine wont start
How to Change the Oil in a Push Lawnmower (Example: Craftsman, Murray, Briggs & Stratton Engines)
How to Change the Oil in a Push Lawnmower (Example: Craftsman, Murray, Briggs & Stratton Engines)

Before installing the new filter, coat the rubber gasket with fresh engine oil. This helps create a better seal and makes it easier to remove the filter during the next oil change. Screw on the new filter by hand, ensuring it's tightened properly but not-overtightened.

Refilling the Engine with Fresh Oil

Once the old oil has completely drained, wipe around the oil pan to remove any residue. Reinstall and tighten the oil pan drain plug using your socket wrench.

AD

Now, it's time to refill the engine with fresh oil. Use your oil funnel to prevent spills and pour in the recommended amount of oil - usually 24 oz for Briggs & Stratton mowers. Allow the oil to settle for a few minutes, then check the dipstick to ensure the level is within the 'Full' range.

Finalizing the Oil Change

Reattach the oil filler cap and dipstick, ensuring they're secure but not overly tightened.

Finally, run your engine for about a minute to allow the new oil to circulate. Turn off the engine and let it sit for another few minutes to give the oil time to settle. Recheck the oil level on the dipstick, adding more oil if necessary to keep it within the 'Full' range.

AD

Congratulations! You've successfully changed the oil in your Briggs & Stratton lawn mower. Regular oil changes are a key part of routine maintenance, ensuring your mower runs smoothly and efficiently. Don't forget to dispose of the used oil responsibly - never pour it down drains or into the trash. Happy mowing!

AD