How to Change Filter on Primo Water Dispenser
Keeping your Primo water dispenser in top shape is essential for enjoying fresh, great-tasting water. One crucial aspect of maintenance is knowing how to change the filters regularly. This guide will walk you through the process step-by-step, ensuring you have clean, filtered water at your fingertips.
Before we delve into the process, let's understand why changing filters is important. The filters in your Primo water dispenser remove impurities, enhance taste, and improve safety. Over time, they can become blocked or lose their effectiveness, making filter replacement a necessary task.
Primo RO (Reverse Osmosis) Filter Replacement
The RO filters in Primo dispensers reduce a wide range of contaminants, including lead, cadmium, and chlorine. Here's how to change them:
1. Safety First: Turn off the water and unplug the dispenser. Allow the water to fully drain from the system.
Changing the RO Membrane Filter
1. Access the Filter Housing: Locate the filter housing at the back of the unit. Open it by turning the knob counterclockwise.
2. Remove the Old Filter: Push the filter out gently using the tab supplied with your new filter. If you don't have the tab, use a small, strong piece of plastic or a spoon.
Changing the Sediment and Carbon Pre-Filters
1. Locate the Pre-Filters: In the filter housing, you'll find these filters stacked one on top of the other.
2. Remove the Old Filters: Remove the top sediment filter first, then gently tap it to loosen any stored particles. Next, remove the carbon filter. Again, use the tab or a small, sturdy piece of plastic if needed.
Primo UC (Ultra-Clean) Filter Replacement
Primo UC filters reduce chlorine, improve taste, and remove odors. Here's how to replace them:
1. Prepare Your Dispenser: Turn off the water and unplug the unit. Open the filter compartment by pulling firmly on the customer-access door.
Replacing the UC Filter
1. Remove the Old Filter: Twist the filter counterclockwise to unlock it. Pull it straight out and discard it.
2. Insert the New Filter: Align the arrows on the new filter with the arrows on the filter mount, then push the filter in until it's fully seated. Twist it clockwise to lock it into place.
Congratulations! You've successfully replaced the filters in your Primo water dispenser. Regular filter changes will ensure that your water stays fresh, clean, and delicious. Why not set a reminder on your phone to replace the RO and sediment filters every six months and the activated carbon filter every three months? Enjoy your Primo water godspeed!