How to Change a Water Filter in a KitchenAid Refrigerator
Changing the water filter in your KitchenAid refrigerator is a crucial maintenance task that ensures clean, fresh water. This guide will walk you through the process step-by-step, making it a simple task to keep your appliance running smoothly.
Before we begin, ensure you have a new filter (KitchenAid's original EveryDrop water filter is recommended) and have unplugged your refrigerator to avoid any electrical accidents. Additionally, place a towel or pan underneath the water line to catch any drips.
Locating and Removing the Old Filter
The first step is to locate the old filter. On most KitchenAid models, it's located behind the lower right-hand door panel. If it's not visible, you might need to remove the panel first.
Once located, turn the old filter counterclockwise to loosen it. Hold the filter firmly and turn it gently, as turning too quickly can cause it to fall or leak. It should take around one to two full turns to completely remove it.
Identifying the New Filter
Before installing the new filter, ensure it's the right one for your model. KitchenAid offers various filters, so it's crucial to match the number and model on your old filter. You can also check your user manual or register your product on KitchenAid's website to find the correct filter.
When you receive your new filter, it will likely be protected by a blue cap and have a silver wrapper around it. Remove these, rinse the filter with cold water, and set it aside.
Installing the New Filter
With the old filter removed, it's time to install the new one. Before inserting it, make sure the filter is level with the opening. Then, turn it clockwise to tighten it. It should take approximately one to two full turns to securely fasten it.
Once installed, run the water dispenser for about four minutes to remove any air in the new filter. This will also prime your filter and ensure the water you enjoy is fresh and clean.
Resetting the Filter Indicator (if applicable)
After installing the new filter, you may need to reset the filter indicator light on your refrigerator's control panel. Consult your user manual for specific instructions, as the process can vary slightly across models.
Once reset, the indicator light will signal when it's time to replace your filter again. KitchenAid recommends replacing your water filter every six months or after 200 gallons of use.
Congratulations! You've successfully changed the water filter in your KitchenAid refrigerator. Regular maintenance like this will keep your water source -- and your appliance -- performing at its best.