Change Husqvarna Chainsaw Chain: Step-by-Step Guide
We've all been there - you're in the middle of a DIY project, hacking away at that troublesome log, when suddenly your Husqvarna chainsaw starts acting up. Upon inspection, you realize it's time for a **chain change**. Don't let this setback slow you down. In this comprehensive guide, we'll walk you through the process of replacing a Husqvarna chainsaw chain like a pro. Let's dive in!
Before we proceed, safety should always be our top priority. Remember to always unplug your chainsaw before making any adjustments. Also, make sure the chain has fully stopped moving before you touch it. Now, let's get started!
Preparation: Gather Your Tools and Materials
Before you begin, make sure you have these tools and materials on hand:
- New Husqvarna chainsaw chain (ensure it's the correct type for your model)
- Scratch awl or aneapolis point chisel
- ablo® ChainSharp™ filing guide (optional, but recommended)
- Fuel and oil to replenish after the change
Once you've gathered everything, it's time to move on to the next step.
Removing the Old Chain
First, you'll need to remove the old chain. Start by loosening the chain pollutant adjuster screw, located on the right side of the crankshaft. Next, slacken the chain tension by turning the chain tensioning screw clockwise. With the chain now loose, you can carefully pull it off the saw's sprocket.
Now, remove the bar nut from the bottom of the bar, using a screwdriver or a bar nut wrench. This will allow you to slide the old chain off and discard it. Remember to note the direction of the chain to ensure you install the new one correctly.
Installing the New Chain
Before installing the new chain, ensure it's the correct type for your Husqvarna chainsaw model. The right chain will have the same number of drive links and cutter links as your previous one. If you're unsure, consult your user manual or look up the chain number on Husqvarna's official website.
With the new chain ready, align it with the bar, ensuring the drive links are correctly positioned. Slip the chain onto the bar, and slide it onto the sprocket. Tension the chain by turning the chain tensioning screw counterclockwise until the chain is taut. Next, tighten the chain pollutant adjuster screw. Lastly, replace the bar nut and secure it firmly.
Oiling and Testing Your New Chain
Now that your new chain is installed and the bar is properly tensioned, it's time to oil and test your Husqvarna chainsaw. Apply a small amount of bar and chain oil to the oil reservoir, following your user manual's guidelines. Pull the chainsaw's starter rope to engage the oiler and ensure oil is reaching the chain.
Once you've confirmed the oiler is working, start your chainsaw and let it run for a few minutes to allow the chain oil to circulate. Now, you can carefully perform a few light cuts to bed in the new chain and test its performance.
Sharpening Your New Chain
Before you start your next project, it's a good idea to sharpen your new chain. Using an **ablo® ChainSharp™ filing guide** or a manual filing technique, file the chain's cutters at the correct angle (usually 30°). Follow the guides provided in your user manual or on Husqvarna's official website for a precise and safe sharpening process.
Remember to only file the cutters on one side of the chain until you've gone halfway around. Then, flip the chain over and file the next set of cutters. This ensures the chain wears evenly. With your new chain sharpened, you're ready to tackle your next DIY challenge!
And there you have it - you've successfully changed your Husqvarna chainsaw chain! With a little practice, this process will become second nature, ensuring your chainsaw stays in top condition and ready to tackle any task you throw at it. Happy sawing!