"Adjust Your Briggs & Stratton Governor: A Step-by-Step Guide"
Ah, the hum of a well-tuned engine! If your Briggs and Stratton engine is sounding a bit off, it might be time to adjust the governor. The governor is the engine's brain, controlling its speed and efficiency. Don't worry if it sounds like a daunting task. This comprehensive guide will walk you through, step by step, making the process as smooth as a perfectly tuned engine. So, let's dive in.
Before you start, ensure your engine is cool and you've got some basic tools on hand: a ratchet, a wrench or pliers, and a flat-head screwdriver. Safety first: always wear gloves and glasses when working on your engine.
Understanding the Governor
The governor in a Briggs and Stratton engine consists of a governor arm, governor pivot pin, governor spring, governor lever, and governor override spring. Understanding these components will help you diagnose and fix common issues.
Let's break down each part: the governor arm senses the engine's speed by measuring centrifugal force. As the engine RPM increases, the governor arm moves outward, applying pressure to the governor lever. This, in turn, controls the fuel supply to the carburetor, keeping the engine speed consistent.
Governor Arm Adjustment
If your engine is revving too high, the governor arm might be set too loose. Tightening it can bring the engine speed down. Here's how:
- Locate the governor pivot pin, usually found at the bottom rear of the engine.
- Using a wrench or pliers, loosen the governor pivot pin nut.
- Rotate the governor arm clockwise to decrease engine speed, or counterclockwise to increase it.
- Tighten the governor pivot pin nut, securing the new setting.
Remember, a small adjustment (about a quarter turn) can significantly affect the engine speed. So, adjust gradually and repeatedly test the engine.
Governor Spring Adjustment
If your engine is running too high or too low, the governor spring might need adjusting. Here's how to change the spring tension:
- Remove the governor lever reversing screws and governor lever.
- Using a flat-head screwdriver, adjust the governor spring tension by rotating the spring adjustor.
- clockwise to increase spring tension, which will decrease engine RPM. Counterclockwise does the opposite.
- Replace the governor lever and secure it with the screws.
Reassembly and Recheck
After making adjustments, always reinstall any removed parts and double-check your work. Test the engine at no-load and then with a load, adjusting as needed until the engine runs smoothly and efficiently.
Finally, remember that regular maintenance is key to keeping your Briggs and Stratton engine running like a dream. So, keep those adjustment tools handy, and happy tuning!