how to add oil to generac generator

How to Add Oil to Generac Generator: Step-by-Step Guide

By Christopher Lewis
AD

Wondering how to add oil to your Generac generator? You're in the right place. Regular oil changes are crucial for maintaining the longevity and performance of your generator. In this guide, we'll walk you through the process step by step, ensuring your Generac generator stays in tip-top shape.

Before we dive in, let's ensure you have the following tools and supplies ready: a funnel, an oil filter wrench, your generator's owner's manual for specific model information, 10W-30 motor oil (check your manual for recommended oil type), and an oil container to collect the old oil.

Preparing Your Generac Generator

Start by turning off your generator and allowing it to cool down for at least 30 minutes to prevent any burns. Once cooled, ensure it's on a level surface for accurate oil level readings.

AD
Generator oil change part 2
Generator oil change part 2
How to do a Generator Tune Up and Oil Change
How to do a Generator Tune Up and Oil Change
How Often Do You Need To Change The Oil In Your Generator?
How Often Do You Need To Change The Oil In Your Generator?

Check your generator's oil level using the dipstick. If the oil level is low, proceed with the oil change process. If it's full, you might just need to add oil. Always consult your owner's manual for your specific model's oil capacity and recommended oil type.

Draining the Old Oil

Locate the oil pan underneath your generator. It's usually a metal pan at the bottom of the engine with a Petcock valve to control the oil flow. Place your oil container underneath the Petcock valve and open it by turning it counterclockwise. Allow the old oil to drain completely. This may take several minutes.

What Is The Best Oil For A Generac Generator?
What Is The Best Oil For A Generac Generator?
Generator Fuel Guide: Gas, Propane, or Diesel?
Generator Fuel Guide: Gas, Propane, or Diesel?

Once the oil has finished draining, close the Petcock valve by turning it clockwise. Wipe the area clean to remove any oil residue. It's a good practice to dispose of the old oil responsibly, typically at a recycling center or a service station that accepts used oil.

Replacing the Oil Filter

Next, remove the oil filter. Using your oil filter wrench, turn the filter counterclockwise until it's loose enough to remove by hand. Remember to keep the Oil Filter Wrench more for upcoming uses. Before installing the new filter, dip your finger in some new oil and rub it around the filter's rubber gasket. This helps create a better seal.

AD

Screw on the new oil filter by hand, turning it clockwise until the gasket contacts the engine block. Then, give it about three-quarters of a turn to seat the gasket. Do not overtighten. After the filter is replaced, you're ready to add new oil.

Adding New Oil to Your Generac Generator

Using your funnel, slowly pour the recommended amount of new oil into the oil fill hole. Consult your owner's manual for the exact amount needed. Oil the oil fill hole and replace the oil fill cap once you've added the correct amount.

After adding the oil, start your generator and let it run for about 15 seconds to force oil through the engine. Then, turn it off and allow it to sit for about 10 minutes to let the oil settle in the oil pan.

AD

Checking the Oil Level

Recheck the oil level using the dipstick. The oil level should be within the "FULL" range on your dipstick. If it's not, make any necessary adjustments by adding or removing oil in small increments, then rechecking the level.

Once your oil level is correct, turn off your generator, wipe the area clean, and you're all set! You've successfully added oil to your Generac generator. Regular oil changes, just like this one, will keep your generator running smoothly for years to come.

Remember, everyone's maintenance routines are a bit different. So, bookmark this page for future reference or share it with other Generac generator owners. Happy maintenance!

AD
AD