how to add oil to generac generator

Effortlessly Add Oil to Your Generac Generator

By David Taylor
AD

Regular maintenance is crucial for ensuring your Generac generator functions at peak performance. One crucial aspect of this upkeep is correctly adding oil to your generator. This article will guide you through the process, ensuring your generator continues to serve you reliably.

Before we dive in, ensure you have the following on hand: a funnel, fresh engine oil (SAE 10W-30 or 15W-40 as recommended by Generac), and a wrench that fits your generator's oil filter. Once you have these, let's get started.

Preparing Your Generator

Before adding oil, let your generator cool down for about 30 minutes. Adding oil to a hot engine can cause burns and may lead to inaccurate oil level readings.

AD
Generator oil change part 2
Generator oil change part 2
How Often Do You Need To Change The Oil In Your Generator?
How Often Do You Need To Change The Oil In Your Generator?
What Is The Best Oil For A Generac Generator?
What Is The Best Oil For A Generac Generator?

Next, locate the oil fill hole on your generator. It's usually positioned on the side of the engine. Using your funnel, pour a small amount of oil into the hole and run the engine for about 15-30 seconds. This helps coat the inside of the engine and is part of the initial break-in process.

Checking the Oil Level

Now that the engine is running, you can check the oil level. Stop the engine and wait for the oil to settle, usually about five minutes. Then, locate the oil dipstick, typically positioned near the oil fill hole.

Generator Fuel Guide: Gas, Propane, or Diesel?
Generator Fuel Guide: Gas, Propane, or Diesel?
How To Change Oil In A Champion Dual Fuel Generator
How To Change Oil In A Champion Dual Fuel Generator

Checking the Oil Level Correctly

The dipstick has markings for "FULL" and "ADD OIL." Pull the dipstick out completely, wipe it clean with a cloth, and then reinsert it fully. Pull it out again and note the oil level. If the level is below "FULL," your generator needs more oil.

Adding the Right Amount of Oil

If the oil level is below "FULL," add oil through the fill hole, again using your funnel, until the level reaches "FULL" on the dipstick. Remember, it's better to add oil gradually and check the level frequently to avoid overfilling. Adding too much oil can lead to oil leaks and other issues.

AD

Replacing the Oil Filter

While adding oil, it's a good idea to replace the oil filter too. Manufacturers suggest replacing the oil filter after the first use and every 200 hours of operation afterward. Consult your owner's manual for the specific recommendation for your generator.

Removing the Old Oil Filter

First, drain the old oil. There's usually a drain plug at the bottom of the engine. Place a container underneath, loosen the plug, and allow the oil to drain completely. Then, remove the oil filter by turning it counterclockwise with your wrench.

Installing the New Oil Filter

Before installing the new filter, apply a light coat of new oil to the filter's rubber gasket. This aids in the initial startup of the engine. Once you've done this, hand-tighten the new filter onto the engine by turning it clockwise. Be careful not to overtighten.

AD

After replacing the oil and oil filter, start your generator and let it run for a few minutes to allow the new oil to circulate. Check for any leaks around the oil filter. Recheck the oil level after the engine has cooled down. If the level is still too low, add a little more oil.

Congratulations, you've successfully added oil to your Generac generator! Regular oil changes and maintenance will ensure your generator continues to provide reliable service for years to come. Don't forget to schedule regular maintenance and keep your generator's owner's manual handy for specific instructions.

AD