How to Replace a Toilet: Step-by-Step Video Guide
Has your toilet seen better days? Is it time for a change? Replacing your toilet might seem like a daunting task, but with the right guide and a few essential tools, it can be a straightforward DIY project. Let's walk you through the step-by-step process to easily replace your old toilet with a new one.
Before you get started, ensure you have all the necessary tools and materials. You'll typically need a new toilet, adjustable wrench, screwdriver, putty knife, sealant, and a hacksaw. Also, prepare your space by covering the floor to protect it from potential damage.
Preparation: Turning Off Water Supply and Draining the Toilet
Start by turning off the water supply to your toilet. The valve is usually located behind the toilet or under a sink nearby. Once the water is off, flush the toilet to empty the tank and bowl.
disconnect the water supply line from the valve at the base of the toilet. Use an adjustable wrench to loosen and remove the line. Be cautious, as there may be residual water in the line.
Removing the Old Toilet
Next, remove the nuts and bolts securing the toilet to the floor. They're usually covered with a cap or hidden behind the water supply line. You may need a special tool or a hacksaw to cut the bolts if they're new and heavily corroded.
Once the bolts are out, use wedges or blocks of wood to gently wobble and rock the toilet back and forth until it's free from the floor-mounted bolts. Now, you can carefully lift the toilet off the floor and move it out of the way.
Preparing the Area
With the old toilet out, inspect the floor for any damage or wear. If necessary, make any repairs before proceeding.
Clean the underside of the floor bolts and the floor surface itself. A putty knife can help remove any leftover caulk or wax. Also, clear away any old bolts, as they may have broken off during removal.
Installing the New Toilet: Assembling the Parts
Before you start installing the new toilet, lay out all the pieces and read the manufacturer's instructions. While most toilets are alike, there may be variations in installation based on the specific model.
Assemble the new toilet by attaching the tank to the bowl using theprovided bolts and washers. Make sure the tank is securely fastened and level.
Positioning the New Toilet
Carefully position the new toilet over the floor bolts. Ensure that the bolts are protruding through the holes in the base of the toilet.
Gently lower the toilet until it's sitting level and flush against the floor. Inspect the wax ring, which seals the base of the toilet to the drain. If you spot any damage, replace it.
Securing the Toilet to the Floor
Once the toilet is in place, attach the nuts provided with the toilet kit. Use an adjustable wrenches to tighten the nuts evenly, ensuring the toilet remains level and secure. Be careful not to overtighten, as this could crack the toilet or break the bolts.
Use a bead of sealant to caulk around the base of the toilet. This will ensure a watertight seal and prevent water damage to your floor. Allow the caulk to dry for several hours before using the toilet.
Reconnecting the Water Supply
Finally, reattach the water supply line to the valve behind the toilet. Use an adjustable wrench to hand-tighten the fitting. Then, turn on the water supply to test for leaks.
Flush the toilet several times to remove any remaining air from the line. Observe the toilet to ensure it's functioning properly and that there are no leaks.
There you have it! You've successfully replaced your old toilet with a new one. With a little patience and the right technique, you've not only saved money by doing it yourself but also gained a new skill. Now, every time you flush, you can be proud that you've handled the job like a pro.