how to wire two lights with one switch

How to Wire Two Lights with One Switch

By Andrew Wilson
AD

When it comes to home improvement, electrical tasks often seem daunting. However, learning how to wire two lights with one switch is surprisingly achievable and canoboost your home's functionality and ambiance. Not only will you enhance your space, but you'll also understand your home's electrical system better. So, grab your toolbox and let's dive into this DIY project.

Before you begin, ensure you switch off the power at your circuit breaker. Always prioritize safety when working with electricity. Now, let's explore the process step-by-step.

Planning and preparation

Organizing your workspace and gathering the necessary materials will save you time and energy during the installation. Here's what you'll need:

AD
How to wire a 2-way switch
How to wire a 2-way switch
How to wire two lights to one switch: the best guide
How to wire two lights to one switch: the best guide
How To Wire Two Light Switches With One Power Supply - Hunker
How To Wire Two Light Switches With One Power Supply - Hunker
  • 14/3 non-metallic (NM) sheathed electrical cable (also known as Romex)
  • 14/3 electrical cord connector (bare wire connector or wire nut)
  • 14/3 electrical tape
  • Switch (ensure it's appropriate for your circuit, usually a single-pole switch)
  • Two light fixtures (ensure they're compatible with your electrical circuit)
  • Voltage tester (to confirm power is off)
  • Wire stripper
  • philosophe bit screwdriver (usually a #2)
  • Flathead screwdriver

Wiring the switch

Start by running the 14/3 cable from your power source to the switch location. Ensure the cable has sufficient length to reach both light fixtures. Fish the cable through the wall, if necessary, using a fish tape.

Strip about 2-3 inches of sheathing from the cable at the switch box. You'll notice three individual wires inside: a black (hot), white (neutral), and bare (ground). Strip about 3/4 inch of insulation from each wire.

Grounding the switch

Before you connect the hot and neutral wires, ground the switch for safety. Tighten the green screw provided on the switch, wrap the bare ground wire around it, and secure it with a screwdriver. Alternatively, if your switch has a pigtail, attach it to the green screw and wrap the ground wire around the pigtail.

Now, connect the black and white wires to the appropriate terminals on the switch. The black wire goes to the brass-colored terminals, and the white wire goes to the screw labeled "white" or marked with a line. Tighten securely using a screwdriver.

AD

Wiring the lights

Run the cable from the switch to each light fixture. At each light box, strip about 2-3 inches of sheathing and expose the individual wires as before.

Wiring the first light fixture

At the first fixture, connect the black wire to the black (hot) terminal on the fixture. Connect the white wire to the white (neutral) terminal. Finally, connect the ground wire to the green terminal or the metal casing of the fixture.

Tuck the wires into the fixture box, making sure no wires are exposed. Secure the fixture to the electrical box using the provided screws. Repeat this process for the second light fixture.

AD

Checking your work

Before restoring power, double-check your connections and ensure no wires are exposed. Verify that each wire is securely fastened to its respective terminal. Then, turn the power back on at your circuit breaker.

Use a voltage tester to ensure power is present at both light switches. If everything is wired correctly, turning the switch should activate both light fixtures simultaneously.

You've just mastered a valuable electrical skill – congratulations! Remember, if you feel unsure about any aspect of the process, consult a professional electrician. Always prioritize safety when working with electricity. Your newly installed lights not only enhance your space but also showcase your newfound electrical prowess.

AD
AD