How To Wire 2 Dual 4 Ohm Subs
Wiring two dual 4 ohm subwoofers, also known as dual voice coil (DVC) subs, requires careful planning to ensure optimal performance and safety. This guide will walk you through the process step-by-step, ensuring your system delivers the rich, powerful bass you desire.
Before you begin, gather your materials: two dual 4 ohm subwoofers, a mono amplifier with 4 ohm stable impedance, speaker wire (14 or 16 gauge), wire strippers, terminal connectors, and optionally, an oscilloscope for testing.
Understanding Dual 4 Ohm Subwoofers
Dual voice coil subwoofers are designed with two voice coils that share a common gap in the magnet. This allows for more redundancy and flexibility in wiring configurations.
They can be wired in series, parallel, or bi-amped, each with its own advantages. We'll focus on the most common methods: series and parallel.
Series Wiring
Series wiring increases impedance and decreases power handling. It's ideal when your amp requires an 8 ohm load. Connect both voice coils in series, using one wire to connect the positive terminal of one sub to the negative terminal of the other.
Use the remaining wires to connect to your amp. Series wiring lowers power handling, so ensure your amp can safely drive the load.
Parallel Wiring
Parallel wiring decreases impedance and increases power handling. It's useful when your amp requires a lower impedance load like 2 ohms. Connect one voice coil of each sub to each other, then connect the remaining wires to your amp.
Parallel wiring increases power handling, ensuring your amp can safely drive the load without excessive distortion or heat.
Wiring the System
Once you've chosen your wiring configuration, strip the insulation from your speaker wire, exposing enough copper to make a secure connection.
Connect the wires from your subs to your amp, ensuring all connections are tight and secure. Use terminal connectors if needed.
Grounding and Power Connectors
Ground both subs to the same point on your amp. This ensures proper ground loop isolation and prevents hum or buzz. Connect the power wires from both subs to your amp's power input.
Ensure all wires are securely connected and twisted to prevent electromagnetic interference (EMI) and radio frequency interference (RFI).
Testing the Setup
Using an oscilloscope or a multimeter, test your speaker wire resistance. It should match your chosen wiring configuration's impedance (4 ohms for series or 2 ohms for parallel).
Play some bass-heavy music and listen for any distortion, hum, or buzz. If everything is functioning correctly, you should hear clean, powerful bass from both subwoofers.
Congratulations! You've successfully wired two dual 4 ohm subwoofers. Regularly monitor your setup to ensure it's performing as expected and have fun enjoying your new bass-heavy system.