how to use fixodent on a crown

How to Use Fixodent on a Dental Crown

By Michael Wilson
AD

If you've got a dental crown and it's popped off, don't panic. You can temporarily secure it back onto your tooth using fixodent, a denture adhesive. Here's a step-by-step guide on how to do this, and some important information to keep in mind.

Before you proceed, ensure your hands are clean and dry. Also, make sure your crown and the tooth it goes on are clean. If not, gently clean them using a soft toothbrush and warm water. Never use hot water as it can damage your crown.

Preparing Your Crown and Tooth

Getting your crown and tooth ready is crucial for the fixodent to adhere properly.

AD
Fixodent VS Poligrip
Fixodent VS Poligrip
How to make a Temporary Tooth 🦷 Crown at home 🏠
How to make a Temporary Tooth 🦷 Crown at home 🏠
How to wear HAIR crown ✅
How to wear HAIR crown ✅

Ensure your crown fits perfectly. If there's food debris or plaque, gently clean it with a soft brush and warm water. Be careful not to damage the crow.

Cleaning and Drying Your Tooth

Your tooth should be clean and dry for the fixodent to adhere. Use a dry, soft-bristled toothbrush or a cotton swab to gently clean the area around your tooth.

Replacement of two PFM crowns with zirconia restorations
Replacement of two PFM crowns with zirconia restorations
a person painting the crown molding on a ceiling with white lettering that reads crown molding return
a person painting the crown molding on a ceiling with white lettering that reads crown molding return

Rinse with water and pat dry with a clean towel. Make sure your tooth is completely dry as moisture can prevent the fixodent from sticking.

Preparing the Fixodent

Fixodent comes as a powder or a cream. If you're using the powder, mix it with a small amount of water according to the package instructions until it reaches a smooth consistency.

AD

If you're using a cream-based fixodent, it's already ready to use. However, ensure it's at room temperature for the best adhesion.

Applying Fixodent to Your Crown

Once your crown and tooth are ready, you can apply the fixodent.

apply a small amount of fixodent to the inside of your crown. The quantity should be enough to cover the surface that touches your tooth, but not too much that it spills over when you bite down.

AD

Attaching the Crown

Carefully place the crown over your tooth, making sure it's in the correct position and fits properly. Apply gentle pressure to ensure it's well-seated.

Be careful not to bite down too hard immediately. Give the fixodent some time to set. According to the package instructions, this usually takes a few minutes.

Testing the Crown

Once the fixodent has set, gently bite down on the crown to test its stability. It should feel secure and not wobble.

AD

If it feels loose or wobbles, you may need to remove the crown, clean your tooth and the crown again, and reapply the fixodent. Be patient, as this might take a few tries.

Important Reminders

Remember, fixodent is a temporary solution. It's highly adhesive and can be quite strong, but it's still not a permanent solution for a loose crown.

While waiting for your dentist appointment, avoid chewing hard or sticky foods as they can dislodge your crown. Also, maintain good oral hygiene to prevent infections.

It's crucial to visit your dentist as soon as possible. They can provide a permanent solution and ensure your tooth remains healthy. In the meantime, take good care of your crown and tooth to prevent further damage or discomfort.

AD