how to unplug kidde smoke detector

How to Unplug Kidde Smoke Detector

By Nicole Robinson
AD

From time to time, it becomes necessary to replace or clean Kidde smoke detectors. But what if it's just a temporary quiet space you desire? Here's a guide on how to unplug a Kidde smoke detector for short periods without causing any permanent damage.

Disclaimer: This guide is for short-term temporary unplugging. Never disable smoke detectors for extended periods or ignore malfunctioning alarms. Always ensure the batteries are fresh and the device is correctly installed. In case of an emergency, functional smoke detectors can save lives.

Unplugging the Kidde Smoke Detector

The most straightforward way to disable a Kidde smoke detector is by unplugging it, but only if it's hardwired with backup batteries. For AC-powered only models, refer to the "Removing the Battery" section.

AD
How to Install a New Hard-Wired Smoke Alarm
How to Install a New Hard-Wired Smoke Alarm
How To Stop A Wired Smoke Detector From Beeping – Storables
How To Stop A Wired Smoke Detector From Beeping – Storables
Install smoke alarm, Carbon Monoxide and Smoke Alarm Combination Installation video Kidde hardwire
Install smoke alarm, Carbon Monoxide and Smoke Alarm Combination Installation video Kidde hardwire

You can unlatch the smoke detector from its base or disconnect the power wire from the device. Here's how:

Disconnecting from the Base

Kidde smoke detectors snap into their bases. Gently pull the edges of the detector while pushing the release tabs on the sides. With a little bit of wiggling, it should pop off.

How to Stop a Smoke Detector From Chirping – 3 Quick Fixes
How to Stop a Smoke Detector From Chirping – 3 Quick Fixes
How to Change a Battery in a Kidde Smoke Detector | 9 Steps
How to Change a Battery in a Kidde Smoke Detector | 9 Steps

Remember, pressing the test button does not disable the alarm. It's still active and will sound if it senses smoke or fire. Only unplugging or removing the battery disables it completely.

Unplugging the Power Wire

Some Kidde models have a connector on the wire leading to the power supply. Carefully unplug this connector to disconnect the smoke detector. Ensure you're pulling the connector, not the wire, to avoid strain.

AD

If your model doesn't have a connector, you'll need to access the electrical box. Turn off the power at the circuit breaker, then carefully unscrew the box cover and disconnect the wire. Always double-check the power is off before working on electrical components.

Battery Removal (for AC-Powered Only Models)

If your Kidde smoke detector runs on AC power only, you'll need to remove the battery to silence the alarm. This power source is usually a 9V or 12V battery.

Always ensure you have fresh batteries on hand if you plan to reconnect your smoke detector.

AD

Opening the Detector Case

Typically, you'll find a small slot on the side of the detector case. Using a flathead screwdriver or a coin, gently pry open the cover. It may take some wiggling, but it should snap open.

If you can't locate the slot, try locating any screws on your model. Use an appropriate screwdriver to remove them, then carefully open the case.

Removing the Battery

Once open, locate the battery compartment. It's usually at the top or side. Take out the battery by gently pulling it out with your fingers. If it's stuck, use a coin or a small tool to carefully elevate it.

AD

Always remember to put the cover or screws back in place once you're done. Leaving the case open can allow dust and insects in, affecting the device's performance.

Your temporary quiet space is now secure. Keep an eye on the time andplug the smoke detector back in as soon as possible. Regularly test your smoke detectors to ensure they're functioning correctly. Spring cleaning is an excellent time to replace batteries and perform these safe checks.

AD