how to tell if a surfboard is waterlogged

Identifying a Waterlogged Surfboard: A Quick Guide

By Amanda Garcia
AD

Have you ever picked up a surfboard, only to find it feels ridiculously heavy and buoyant? Chances are, you're holding a waterlogged surfboard. A waterlogged surfboard, filled with water inside its core, can hinder your surfing experience, make the board difficult to control, and even pose safety risks. Here's how to tell if your surfboard is waterlogged and what you can do about it.

Firstly, it's crucial to understand that surfboards are not designed to absorb water. Most modern surfboards are foam cores wrapped in fiberglass or carbon fiber, which are waterproof. Older surfboards, however, might have foam interiors that can take on water over time. Whatever the case, a waterlogged surfboard is never a good sign.

Visual Inspection

Before you even get your surfboard wet, perform a visual inspection for signs of water intrusion. Water entry points can be visible, such as cracks, delamination, or stress fractures on the board's surface.

AD
Tips to Pop Up on a Surfboard like Advanced Surfers
Tips to Pop Up on a Surfboard like Advanced Surfers
How to restore a broken surfboard - Full Tutorial
How to restore a broken surfboard - Full Tutorial
the instructions for surfboarding breaks are shown in this drawing, which shows how to break
the instructions for surfboarding breaks are shown in this drawing, which shows how to break

Check the stringer, the longitudinal wooden strip running down the middle of the board. If it's bending or twisting strange, it might be filled with water. Water can also cause the deck to bubble or warp. Remember, surfboards should be smooth and flat, not warped or misshapen.

Weight and Buoyancy

Pick up the surfboard and feel its weight. A waterlogged board will feel heavier than usual, and it might also float higher in the water due to its increased buoyancy. Even small boards filled with water can feel like a boulder when you try to carry them.

How To Clean Your Surfboard | CleaNESTOR
How To Clean Your Surfboard | CleaNESTOR

Try holding the board at a 45-degree angle to the surface of the water. If water flows out of the board, it's a clear indication that it's waterlogged.

Sound Test

Tap gently on the board's surface. Listen for a dull thud instead of the characteristic sharp, resonant sound of a dry surfboard. This is due to the sound absorbing properties of water inside the board.

AD

To get a better sense of where the water is, try tapping at different points. You might hear a change in tone where the water is concentrated.

Internal Inspection

If the external signs are evident, it's time for an internal inspection. This involves slicing open the surfboard to check the foam core directly. Before you do, make sure it's a surfboard worth saving - if it's severely damaged, it might be best to buy a new one.

If you decide to proceed, use a sharp knife to cut a small hole in the deck, near an area where you suspect water might be present. Blow air into the hole using a compressor or an inflatable ball pump. If water bubbles out, the board is indeed waterlogged.

AD

Repairing a Waterlogged Surfboard

If the foam core is not too damaged, you can attempt to repair the surfboard. First,ék out any waterlogged foam using a sharp knife. Then, apply a surfboard repair kit to fill and seal the void left by the waterlogged foam.

Finally, sand and fiberglass the repair area, ensuring the surfboard remains waterproof. Keep in mind that the repaired area might affect the board's performance, and it won't be as strong as the original construction.

With a little extra care and maintenance, your surfboard can last for years. But if it ends up waterlogged, don't despair. Use these tips to inspect and repair your board, and you'll be catching waves again in no time. Next time, though, keep an eye on that surfboard and never leave it unsupervised in the water. Happy surfing!

AD
AD