how to start a ford explorer

Easy Steps to Start Your Ford Explorer: A Comprehensive Guide

By Anthony Martinez
AD

Starting your Ford Explorer on a cold winter morning or a hot summer day can sometimes be a challenge. Whether you're dealing with a dead battery, a finicky starter, or simply forgetting to turn off your lights, we've all been there. Here's a comprehensive guide on how to start your Ford Explorer under various conditions.

Before we dive in, ensure that your Explorer is in a safe location, with the parking brake engaged and the transmission in 'P' or 'N' for manual transmissions. Always consult your owner's manual for vehicle-specific information.

Troubleshooting Common Starting Issues

Before you begin troubleshooting, check your gauges and warning lights. If the Engine light or an immobilizer warning is lit, address those issues first. Remember, safety first – if your Explorer won't start and you suspect a serious issue, contact a professional mechanic.

AD
Ford Explorer Workshop Service Repair Manual
Ford Explorer Workshop Service Repair Manual
Troubleshooting Ford Explorer Charging Issues
Troubleshooting Ford Explorer Charging Issues
Ford Explorer Service Repair Manual
Ford Explorer Service Repair Manual

Now, let's tackle some common scenarios.

Dead Battery

Battery issues are one of the most common reasons your Ford Explorer might not start. If your battery is more than 3 years old, it's a good idea to check its condition periodically. Here's how to start your Explorer with jumper cables:

11 Common Ford Explorer Problems | Years To Avoid
11 Common Ford Explorer Problems | Years To Avoid
How to Reset the Oil Life on a 2013 Ford Explorer
How to Reset the Oil Life on a 2013 Ford Explorer
  • Make sure both vehicles are turned off and the parking brakes are engaged.
  • Connect the jumper cables in the correct sequence: positive to positive, then negative to the good battery's ground and finally, connect the negative cable to a non-painted metal surface under the hood of the vehicle with the dead battery.
  • Start the good vehicle and let it run for a few minutes. Try starting your Explorer. If it starts, let it run for a few minutes before disconnecting the jumper cables in the reverse order.

Frozen or Flooded Engine

If you've parked your Explorer outdoors, it's possible that the engine could be frozen or even flooded with water, especially during the colder months. Here's how to deal with each issue:

  • Freeze: Park your Explorer in a garage or a covered area when possible. If this isn't an option, let your vehicle warm up gradually in a safe location. Do NOT rev the engine to speed up the process as this can cause severe engine damage.
  • Flooded: If your engine is flooded, it's best to wait for it to dry out. Turn your Explorer's ignition to 'ON' every 15-20 seconds to allow the fuel to evaporate. Once you're sure the engine is dry, you can attempt to start it.

Starting Your Ford Explorer from the Key Fob or Starter Button

Once you've addressed any starting issues, it's time to start your Explorer. Here's how to use both the key fob and the starter button:

AD

Using the Key Fob

If your Explorer is equipped with an Intelligent Access key fob, you have two options to start your vehicle:

  • One-Push Start: Place your foot on the brake pedal, push the start/stop button, and keep it pressed for a few seconds until the engine starts.
  • Keyless Start: Make sure the key fob is in your pocket or bag, then push the start/stop button. Once the engine is running, you can remove your foot from the brake pedal. To turn off the engine, simply push the start/stop button again with your foot on the brake pedal.

Using the Starter Button

If your Explorer is not equipped with the Intelligent Access system, you'll need to use the traditional key to start your vehicle:

Turn the ignition switch to the 'ON' position to turn on the dash lights and accessories. Then, press the accelerator pedal gently to increase the engine's RPM. Finally, turn the ignition switch to the 'START' position. Once the engine starts, release the accelerator pedal.

AD

Now that you know how to start your Ford Explorer in various situations, you're ready to tackle any starting issue that comes your way. Happy driving!

AD