how to set a la crosse technology radio controlled clock

How to Program A La Crosse Technology Radio Controlled Clock

By Kevin Lee
AD

Setting a La Crosse Technology radio controlled clock is not only a breeze but also ensures that you're always in sync with reliable, accurate timekeeping. These clocks are synchronized with Atomic Clock signals, which are the most accurate timing references available. Here's a step-by-step guide on how to set your La Crosse Technology radio controlled clock.

Firstly, ensure that you've plugged in your clock and it's within range of an Atomic Clock signal. The most common signals are from the National Institute of Standards and Technology (NIST) in Colorado and the United States Naval Observatory (USNO) in Washington, D.C., depending on your location and clock model.

Setting Up the Clock

Before you begin, confirm that the batteries in your clock are fresh and that the antenna is properly positioned. The antenna should be upright and away from any metal objects to ensure the best reception.

AD
How To Setup an Analog Atomic Wall Clock
How To Setup an Analog Atomic Wall Clock
La Crosse Technology Radio-Controlled Wall Clock, Silver
La Crosse Technology Radio-Controlled Wall Clock, Silver
WS-8117U-IT-C Atomic Digital Wall Clock
WS-8117U-IT-C Atomic Digital Wall Clock

The initial setup process may take up to 20 minutes as the clock.searches for the signal and sets the time. During this process, the display will show 'TEMP' or 'MOON' or '(', which is normal.

Automatic Set Time Mode

After plugging in your clock, it will automatically start searching for the signal. Once the signal is found, the time will set itself. The display will show 'ATOM' when the signal has been detected and the time is setting.

18" Indoor/Outdoor Atomic Clock with Temperature and Humidity 18.0 H x 18.0 W x 2.6 D in Dark Brown Plastic
18" Indoor/Outdoor Atomic Clock with Temperature and Humidity 18.0 H x 18.0 W x 2.6 D in Dark Brown Plastic
La Crosse Technology Wt-3129s 12" Atomic Analog Silver Wall Clock
La Crosse Technology Wt-3129s 12" Atomic Analog Silver Wall Clock

If your clock doesn't receive a signal automatically, or if you need to manually adjust the time, follow these steps:

Manual Set Time Mode

Press and hold the 'SET' button until the hours display starts to flash. Then, using the 'TIME' and 'TOGGLE' buttons, set the hours, minutes, and AM/PM (if applicable) to the correct time. If your clock has an 'AL/PM' indicator, press 'SET' briefly to toggle between AM/PM and use 'TOGGLE' to set the correct setting.

AD

Once you've set the time, release the 'SET' button. The clock will now search for the Atomic Clock signal to maintain accurate timekeeping.

Adjusting Additional Features

Your La Crosse Technology radio controlled clock likely comes with features like alarms, temperature display, or backlight settings. Here's how to adjust these:

Setting Alarms

Press and hold the 'ALM' button until the alarm indicator starts to flash. Use the 'TOGGLE' and 'SET' buttons to turn the alarm on/off or set the alarm time.

AD

To silence the alarm, press any button. To turn the alarm back on, press the 'ALM' button briefly.

Adjusting Backlight Settings

Your clock may have a backlight feature to make the display visible in low-light conditions. The backlight setting is usually adjusted via the 'SET' and 'TOGGLE' buttons. Consult your clock's manual for specific instructions.

After setting up your clock, it will maintain accurate time by receiving the Atomic Clock signal automatically. There's no need to adjust the time manually for daylight saving time changes or other adjustments. Enjoy the convenience of a hands-free, reliable clock.

AD
AD