Mastering Pull Start Restring: Essential Steps
Restringing a pull start engine, like those found in lawn mowers and string trimmers, is a straightforward task that can extend the life of your tool and save you from expensive repairs. This guide will walk you through the process, from gathering the necessary materials to tying off the new string.
Before you begin, ensure you're working in a well-lit, safe area and have the right tools. You'll need a new spool of string, a pair of sharp scissors or a utility knife, and perhaps a Phillips or flathead screwdriver depending on your engine model.
Preparing Your Engine for Restringing
Begin by disconnecting the spark plug wire to prevent any accidental starting of the engine. Then, locate the string trimmer head and unscrew it by turning it clockwise. You may need to use a screwdriver for this step.
Once the head is removed, you'll see the old string wound around the spool. Carefully cut the string at both ends using your scissors or utility knife. This will release the tension and make it easier to remove the old string.
Choosing the Right String
When selecting a new string, opt for one that's specific to your tool's manufacturer recommendations. Different engines require different types and sizes of string, so always check your user manual first. Typically, you'll be looking for a dimension like '0.080'-'0.095' inches or '1.6'-'2.0' millimeters.
Popular material options include nylon, co-polymer, and hybrid strings. Nylon strings are affordable and versatile, while co-polymer strings are more durable but harder to cut. Hybrids offer a blend of these properties. Consider your specific needs and weigh up the trade-offs before making your decision.
Understanding the Winding Direction
Before you begin winding, observe the old string's direction to ensure you understand how your engine is designed to operate. Most engines follow a counter-clockwise winding pattern. However, it's crucial to double-check this, as a small minority use a clockwise pattern.
To confirm, look for a small arrow or 'wind' notation on the spool. This should point in the direction you'll be winding your new string. If there's no marking, carefully replace the old string in the same direction it was wound initially, and use that as your guide.
Winding the New String
Begin by inserting the new string into the string trimmer head, feeding it through the small hole in the center and out through the eyelet. Leave about a foot (30cm) of string hanging out, as this will be the line that feeds out during operation.
Start winding the string around the spool, following the correct direction indicated earlier. Apply even tension as you wind, keeping your loops close together and ensuring there are no overlaps. Winding too tightly can cause the string to break more easily, while winding too loosely can lead to tangling and misfeeds.
Leaving Room for the Feed Line
As you approach the end of your new string, ensure you leave enough room for the feed line. Typically, this is around 6-10 inches (15-25cm), but always refer to your user manual for specific measurements.
Leave the end of the string sticking out of the spool once you've reached the required length. This will act as the initial feed line when you start your tool. Make sure it's long enough to feed through the head and out of the cutting debris shield.
Reassembling the String Trimmer Head
Once your new string is securely wound, it's time to reattach the string trimmer head. Line up the arrows or notches on the head with those on the engine housing, ensuring they match. Then, begin turning the head counter-clockwise until it locks into place. Be careful not to overtighten, as this can cause damage to the internal mechanisms.
Finally, replace the spark plug wire to re-enable the engine's ignition. Your tool is now ready for use with its fresh, new string. Don't forget to test it out in a safe, open area before turning it on your intended surface.
Regularly restringing your pull start engine ensures optimal performance and prolongs the life of your tool. Always follow safety guidelines when working with your string trimmer, and store it properly when not in use. Happy trimming!