How to Restring a Cordless Cellular Shade
Are your once-crisp cordless cellular shades looking a little limp lately? Don't worry, it's not time to replace them just yet. With a simple restringing process, you can revitalize your window treatments and bring new life to your rooms. Here's a step-by-step guide to help you achieve that.
Restringing your cordless cellular shades is a straightforward process that can be completed in less than an hour, saving you time and money. Before you begin, gather your materials: your shade, a screwdriver, scissors, new cord (ensure it's the same type as the original), and a friend to help you keep the shade steady.
Preparation
Begin by preparing your workspace. Lay out a largish flat surface where you can comfortably extend your cellular shade. Clear the area of any debris or obstacles to ensure a smooth restringing process.
Next, carefully remove the shade from its window bracket. Use your screwdriver to loosen and remove the screw holding the bracket in place. Gently lower the shade from the bracket, using a gentle rolling motion to avoid straining the fabric.
Removing the Old Cord
Start by unwinding the old cord from its spool at the top of the shade. Typically, it will be wrapped around a plastic or metal dowel. Be gentle to avoid damaging the cord or the dowel itself. Once unwound, carefully cut the cord using scissors.
After detaching the cord from the dowel, gently pull it from the bottom of the shade. You may need to use a pair of needle-nose pliers to help you grip and pull the end of the cord. Work slowly and steadily to avoid excessive strain on the fabric.
Doubling the New Cord
Measure the length of the old cord, then cut a piece of new cord to twice this length. This extra length will give you sufficient material to tie knots and ensure a snug fit during the restringing process.
Fold the new cord in half, creating a loop at the midpoint. This loop will be used to attach the cord to the original spool at the top of the shade. Make sure the loop is large enough to fit over the dowel but small enough to keep the cord taut during retensioning.
Restringing the Shade
Begin restringing your shade by inserting the looped end of the new cord into the spool at the top of the shade. Ensure the loop fits securely around the dowel, keeping the cord firmly in place.
Gently pull the two loose ends of the cord from the bottom of the shade. You should feel resistance as the cord feeds through the routed channels within the shade's headrail. Continue pulling until both ends of the cord emerge.
Tensioning the Cord
Find a helper to keep the shade steady as you tension the cord. Pull on the two loose ends simultaneously, working to achieve an even tension across the entire shade. This even tension will ensure your shade raises and lowers smoothly.
Once you've achieved an even tension, tie a secure knot at the bottom of the shade using both ends of the cord. A sturdy bowline knot is an ideal choice, as it won't slip under tension. Ensure the knot is tight and secure, with no loose ends that could become tangled during use.
Testing the Shade
Gently lift the shade to test its new restring. The cord should feed smoothly through the headrail, allowing the shade to raise and lower without resistance. If you encounter any issues, double-check your knot and cord for any snags or tangles.
If the shade raises and lowers smoothly, your restringing job is complete. Reattach the shade to its bracket using the screw you removed earlier, ensuring it's securely fastened to the window frame.
Stepping back to admire your handiwork, you'll notice an immediate difference in your window treatment. Your once-limp cellular shades now look crisp, fresh, and ready to beautifully filter light into your space for years to come. Enjoy the satisfaction of a job well done, and the knowledge that you've saved time and money by tackling this easy DIY project yourself.