How to Reset Brinks 4 Digit Lock: Step-by-Step Guide
Forgotten your Brinks 4-digit lock code? Don't worry, resetting it is a straightforward process. Here's a step-by-step guide to help you regain access to your lock in no time.
Before you begin, ensure you have the original installer code or the master code if you're resetting a shared access lock. If you don't have either, you'll need to call Brinks' customer service for assistance.
Preparation: Gather Your Items
To successfully reset your Brinks 4-digit lock, you'll need a few items:
- Your Brinks 4-digit lock
- The original installer code or master code (if applicable)
- A flathead screwdriver or a small coin
Locate the Reset Hole
The reset hole is typically located at the bottom of the lock, near the battery compartment. It's usually marked with a small "R" or has a small hole next to it.
Important: Do not confuse this with the set screw hole, which is usually marked with an "L" or "S".
Access the Reset Hole
Using your flathead screwdriver or coin, carefully insert it into the reset hole and gently turn it clockwise. You should feel a click when the reset hole is engaged.
Once engaged, pull the lock towards you while continuing to turn the screwdriver or coin clockwise. This will open the lock and expose the battery compartment.
Enter the Reset Mode
With the lock open, you'll see a small button inside. This is the reset button. To enter reset mode, press and hold this button for about 5-10 seconds.
While you're still holding the button, quickly release it and enter the master code (if applicable) or the installer code using the lock's keypad.
Clear the Old Code
After entering the code, wait for a brief beep. This signals that the lock is ready to accept the new code. To clear the old code, press the "0" or "*" button four times.
Some Brinks locks may require you to rotate the reset screw a quarter turn counterclockwise after entering the code and before clearing the old code.
Enter Your New Code
After clearing the old code, wait for another brief beep. This indicates that the lock is now ready for a new code. Enter your new 4-digit code using the lock's keypad. Make sure to enter it slowly and clearly to avoid errors.
After entering your new code, press the "#" or "9" button to confirm. The lock will beep once more to confirm that your new code has been successfully set.
Congratulations! You've successfully reset your Brinks 4-digit lock. If you need to test your new code, close and reopen the lock, then enter your new code. If everything works as expected, your lock is now ready for use with your new code.