How to Reset Annke DVR to Factory Default (No Password)
Before we proceed, ensure you have the DVR monitor or a TV connected to the DVR, and the DVR is powered on. This guide assumes you're using a standard ANKKE DVR model. Other models may have slightly different procedures.
Accessing the Recovery Mode
The process begins by entering recovery mode. Don't worry; this doesn't require any technical expertise. Here's how to do it:
1. First, unplug the DVR from the power source.
2. Press and hold the "Reset" button on the bottom or back of the DVR. Some models may have it at the side.
3. While still holding the "Reset" button, reconnect the power supply to the DVR.
4. Keep holding the "Reset" button for about 15 seconds, then release it.
Entering the Factory Reset Option
Now that you're in recovery mode, let's navigate to the factory reset option:
1. Use the DVR remote control or the buttons on the DVR itself to navigate to the "OK" or "Enter" key.
2. Press the "OK" or "Enter" key to select the " factory reset" option.
3. If prompted to confirm the action, press "OK" or "Enter" again.
Confirming the Reset and Restoring Default Settings
Before you dive in, double-check that you want to proceed. Resetting your DVR will erase all existing settings and configurations.
1. You'll be asked to confirm the factory reset. Press "OK" or "Enter" to proceed.
2. Wait for the process to complete. This might take a few minutes.
3. Once done, the DVR will reboot, and you'll see the setup screen where you can start fresh.
First-Time Setup After Reset
After successfully resetting your DVR, you might want to reconfigure some settings:
1. Connect your cameras to the DVR.
2. Power on the DVR and follow the on-screen instructions to set up your cameras.
3. Remember to set up a new admin password for enhanced security.
Verifying the Reset and Troubleshooting Common Issues
After the reset, ensure everything is working as expected:
1. Check if your cameras are visible and recording correctly.
2. If not, try plugging in the cameras directly to the DVR's power supply rather than through the BNC cable.
3. If the issue persists, ensure your cables and power supply unit are in good working condition.
Congratulations! You've successfully reset your ANKKE DVR to factory default and are now ready to start afresh. If you encounter any other issues, don't hesitate to reach out to ANKKE's customer support for further assistance. Happy monitoring!