Step-by-Step: How to Replace Trunk Lift Supports
Has your vehicle's trunk lift support given out, making it near impossible to access your cargo space? Don't let this common car issue disrupt your daily routine. Replacing the trunk lift supports is a feasible DIY project that can save you time and money. Let's guide you through a step-by-step process to help you replace your trunk lift supports safely and effectively.
Before we dive into the process, ensure you have the right tools and parts. You'll need a replacement lift support (ensure it's compatible with your vehicle make and model), a socket wrench set, a screwdriver, a hammer, and possibly a jack and jack stands, depending on your vehicle type.
Understanding Your Vehicle's Trunk Lift Supports
Trunk lift supports, also known as gas struts, are hydraulic pistons that counterbalance the weight of your open trunk lid, making it easier to lift and hold it in place. They are usually located on either side of the trunk, attached to the vehicle's body and the trunk lid.
There are different types of lift supports, including struts with a fixed length and adjustable ones. The type you have will determine the replacement process. It's crucial to know the difference, so you purchase the correct replacement part.
Identifying Your Lift Support Type
To identify your lift support type:
- Lift your trunk lid carefully.
- Observe how the mechanism acts – if it extends and locks in place, it's likely an adjustable strut. If it extends and then stays at a fixed length, it's a fixed length strut.
Once you've identified the type, measure the length and compare it with the dimensions of replacement parts online or at your local car parts store to ensure an accurate match.
Finding the Right Replacement Lift Support
After determining your lift support's type and size, search for a replacement part from reputable manufacturers like Bosch, Monroe, or Moog. You can order online or visit your local auto parts store and provide them with your vehicle's make, model, and year.
When purchasing, look for lift supports with an appropriate pressure rating, usually 40-65 PSI, and ensure they have the correct attachment points to replace the original ones.
Replacing Your Trunk Lift Supports
Now that you've gathered the necessary parts and tools, let's proceed with the replacement process. The steps below assume you're replacing fixed length struts. If you have adjustable struts, the process may vary slightly.
Always start by ensuring your vehicle is securely parked on a level surface and safely supported with a jack, if necessary. Never attempt to work on your vehicle without first ensuring it's stable and secure.
Removing the Old Trunk Lift Supports
1. Carefully lift your trunk lid until it latches in the open position.
2. Using your socket wrench, loosen and remove the mounting bolts at the top of the lift support, where it attaches to the vehicle's body.
3. Do the same for the bolts at the bottom of the support, where it connects to the trunk lid.
4. With the bolts removed, use a hammer to gently hammer the lift support out, if necessary, as they can be stuck due to rust or wear.
Installing the New Trunk Lift Supports
1. Carefully position the new lift support in place, ensuring the mounting holes align with the original points.
2. Using your socket wrench, thread the mounting bolts back into place, but do not tighten them just yet.
3. Repeat the process for the other side of the trunk. Once both sides are installed, carefully lift the trunk lid to test the new lift supports. If they extend and support the lid, you can now proceed to fully tighten the bolts using a wrench or torque wrench if necessary.
You've now successfully replaced your trunk lift supports! Remember to dispose of the old parts responsibly and always consult your vehicle's owner's manual for specific instructions related to your make and model.
Regularly inspecting your vehicle's lift supports and maintaining them can help prevent future issues and prolong their lifespan. Happy DIYing, and safe travels!