Step-by-Step: Fix Whirlpool Washer Belt Replacement
Dealing with a squeaky or broken belt on your Whirlpool washing machine can be quite the annoyance. But fear not, replacing it isn't as daunting as it may seem. With a few tools and our step-by-step guide, you can breeze through this task like a pro. Let's dive in!
Before you begin, ensure you have the following items on hand: a new WH16X1020 or WH17X1023 drive belt (depending on your model), a Phillips screwdriver, and maybe a second pair of hands to help with keeping your washing machine steady.
Understanding Your Washing Machine's Belt
First, let's get familiar with the drive belt. This aptly-named part is responsible for transferring the motor's power to the washer's inner tub. When it snaps or wears out, your washing machine won't spin, leaving you with a bainette of disappointment.
Whirlpool designs their belts to run on the motor pulley at the back of the washer and the tub's pulley up front. To keep things simple, they've included a convenient polyester belt cover that protects the belt and makes it accessible via the back panel.
Preparation: Accessing the Drive Belt
Start by unplugging your washing machine from the power source to avoid any electrical mishaps. Then, locate the access panel at the back, and tank-specific washers may have additional covers to remove. Using your Phillips screwdriver, remove these covers and set them aside.
Now, you should see the drive belt disappear under the large, white motor pulley. Temporarily replacing the rear cover will help keep things organized and make reassembly easier later.
Removing the Old Belt
Look for the belt tensioner, usually found on the left side of the pulleys. It's a small, movable hook that keeps the belt taught. To loosen the tension, pull it away from the motor pulley. This should allow the belt to move freely.
Now, grab the middle of the belt and slowly pull it off the motor pulley. It might take a bit of wiggling, but it should come off with a little persuasion. Once off, you can discard the old belt – your new one awaits!
Installing the New Drive Belt
Your new belt is ready for action, so let's get it into place. First, identify which way the belt should run based on its original orientation. The textured side should face outwards, and the smooth side inwards.
Begin by placing the new belt over the motor pulley. Then, bring the other end around to the tub pulley, looping it over in the same direction. Keep enough slack so you can reconfigure the tensioner easily.
Securing the New Belt
With the belt in place, gently pull the motor pulley end outwards to create tension. The other end should naturally slip back onto the tub pulley. Once you're satisfied with the tension, secure the tensioner back in place, ensuring the belt is firmly in its groove.
If you're unsure about the tension, don't worry – minor adjustments can be made even after reattaching the back panel. Just double-check that the belt isn't too loose or tight. Too loose can cause slippage, while too tight may strain the motor or tub.
Reassemble and Test
With the belt secure, you can now reattach the back panel and any additional covers you removed earlier. Tuck the new belt's edges nicely under the protective polyester cover to keep everything neat and tidy.
Once reassembled, plug your washing machine back into the power source. Run a test cycle to ensure the new belt is working as expected. The first few cycles might be noisy as the new belt beds in, but it should soon settle down.
Congratulations, you've just successfully replaced the drive belt on your Whirlpool washing machine! Regular maintenance like this will keep your appliance running smoothly and prolong its lifespan. Always remember to consult your owner's manual for model-specific instructions and troubleshooting tips.