Step-by-Step: How to Replace Your Stihl Trimmer Head
If your STIHL trimmer isn't performing as well as it used to, it might be time to replace the trimmer head. This quick maintenance task can significantly improve your trimmer's performance and extend its lifespan. Let's dive into a step-by-step guide to show you how to replace your STIHL trimmer head safely and effectively.
First, it's crucial to have the right tools and parts. You'll need a new STIHL trimmer head, a screwdriver that fits your trimmer's head bolts, and possibly a wrench to loosen the trimmer shaft. Ensure you purchase the correct head for your trimmer model to ensure compatibility and optimal performance.
Preparation and Safety
Before you begin, turn off and unplug your trimmer. Also, make sure the trimmer's engine has cooled down to prevent any brûlure injuries. Always prioritize safety by wearing sturdy gloves, safety glasses, and closed-toe shoes.
Identifying Your Trimmer Head Type
STIHL offers two types of trimmer heads: the Easy2Start and the Autocut. The Easy2Start is simpler to use, with fewer components and no bump-feed feature. The Autocut is more advanced, with a bump-feed feature that allows you to advance line with a quick tap on the ground.
To identify your head type, look at the top of your current trimmer head. If it has a star-shaped hole, it's an Easy2Start head. If it has a central button or knob, it's an Autocut head.
Removing the Old Trimmer Head
Start by securing your trimmer in a upright position, either in a large vise or on a stable workbench. Locate the head bolts on the top of the trimmer head. Using your screwdriver, loosen and remove the bolts. Some trimmers might require you to hold the trimmer's shaft still with a wrench while unscrewing the bolts.
Once the bolts are loose, pull the trimmer head off the trimmer's driveshaft. If the old head is stuck, you can tap it gently with a hammer to loosen it. Be careful not to damage the driveshaft in the process.
Installing the New Trimmer Head
Before installing the new head, ensure that no old line remains inside. For Easy2Start heads, take out the central nut and insert the new line. For Autocut heads, thread the new line through the line release holes in the head and leave enough length (about 10-15 cm or 4-6 inches) for trimming.
Easy2Start Trimmer Head Installation
Place the new trimmer head onto the driveshaft, ensuring the arrow on the head is pointing in the direction of rotation. Align the holes in the head with the drive key on the shaft. Push the head onto the driveshaft until it seats firmly against the washer.
Replace and tighten the head bolts using your screwdriver. Be sure not to overtighten; around 1.5 to 2 Nm of torque is sufficient. Once the bolts are secure, try spinning the head to ensure it rotates freely.
Autocut Trimmer Head Installation
Follow the same initial steps as with the Easy2Start head. After securing the head onto the driveshaft, locate the star-shaped hole on top of the head. Insert the permanent locking pin (included with your new head) into this hole and secure it. This prevents the head from loosening during operation.
Next, engage the bump-feed mechanism by lightly tapping the head on the ground. You should hear and feel the line advance. After checking that the line is feeding properly, tighten the head bolts as explained above.
Congratulations, you've successfully replaced your STIHL trimmer head! Remember to perform this maintenance regularly to keep your trimmer in optimal condition. Always wear the appropriate safety gear when using your trimmer, and never forget to disengage and allow the engine to cool down before performing any maintenance tasks. Happy trimming!