how to replace ipad air battery

How to Replace iPad Air Battery

By Richard Martinez
AD

Has your iPad Air's battery life taken a significant dip lately? It might be time to replace it. Don't worry; you don't have to visit an Apple Store or a repair shop. With the right tools and a bit of patience, you can replace your iPad Air's battery at home. Here's a step-by-step guide.

Before we dive in, ensure you have the following: a Replacement Battery for your iPad Air, an iOpener or hairdryer, a P5 Pentalobe Screwdriver, a #00 Phillips Screwdriver, an iPad opening tool, a Suction Cup, and a Spudger.

Preparation and Initial Disassembly

First, prepare your iPad for the battery replacement. Back up your data to iCloud or your computer. Power off your iPad and remove the SIM card tray if your model has one.

AD
Is It Worth Replacing iPad Battery?
Is It Worth Replacing iPad Battery?
How To: iPad Air Battery Replacement
How To: iPad Air Battery Replacement
I changed 6 settings on my iPad to instantly improve the battery life (by hours)
I changed 6 settings on my iPad to instantly improve the battery life (by hours)

A crucial step is to heat up the iPad's plastic. This makes it easier to pry open. Use an iOpener or a hairdryer to heat the bottom edge of your iPad for about 2-3 minutes.

Removing the Screws and Back Panel

Use your P5 Pentalobe Screwdriver to remove the two Pentalobe screws at the bottom of your iPad. Set them aside in a safe place.

How to replace a tablet battery
How to replace a tablet battery
iPad Pro 9.7 Battery Replacement
iPad Pro 9.7 Battery Replacement

Insert the suction cup on the bottom edge of the iPad, nearest the screw holes. Gently pull up on the suction cup to separate the rear panel from the iPad's frame. Work your way around the edge of the iPad using an iPad opening tool or a flathead screwdriver, prying the panel up from the frame.

Disconnecting the Battery

Remove the 19 Phillips screws securing the logic board to the rear panel. Use a #00 Phillips Screwdriver to avoid stripping the screws. Be careful not to lose these tiny screws.

AD

Use a Spudger to disconnect the battery connector. Insert the Spudger under the battery connector and gently pry it up to disconnect it from the logic board.

Battery Removal and Replacement

Remove the battery from the iPad. To do this, use a Spudger to cut the adhesive securing the battery to the logic board. Be careful not to damage any components.

Remove the old battery. Position the new battery, aligning it with the retention clips on the logic board. Press firmly on the battery to secure it in place. No additional adhesive is necessary.

AD

Reassembly and Testing

Reassemble your iPad, following the disassembly steps in reverse order. Ensure all screws and components are correctly placed and tightened.

After reassembling, power on your iPad. The first boot might take a little longer than usual. Check if the battery indicator shows up and if your iPad is charging properly.

Congratulations, you've successfully replaced your iPad Air's battery! Don't forget to fully charge your iPad to calibrate the battery. Now you can enjoy improved battery life and the peace of mind that comes with knowing you've tackled a repair task independently.

AD
AD