how to replace battery in adt panel

Step-by-Step: How to Replace Battery in ADT Panel

By Nicole Allen
AD

Is your ADT security panel displaying a low battery warning? Don't let a depleted battery compromise your home's safety. Replacing the battery in your ADT panel is a straightforward process that you can accomplish on your own, saving you the time and cost of scheduling a professional service. Here's a comprehensive, step-by-step guide on how to replace the battery in your ADT panel.

Before you begin, ensure you have the following items on hand: a new 12volt alkaline battery (look for an ADT-branded battery or a compatible one recommended by ADT, such as the Duracell MN2500), a Philips screwdriver, and a flathead screwdriver. Let's dive into the process.

Preparing Your ADT Panel for Battery Replacement

Begin by turning off your ADT panel to ensure no power is running through the system during the battery replacement. To do this, locate the 'Ready to Arm' light on your panel and press it until the panel displays 'Off'.

AD
Battery Change Ademco Lynx Control Panel
Battery Change Ademco Lynx Control Panel
How to Replace ADT Window Sensor Battery
How to Replace ADT Window Sensor Battery
Change Adt Safewatch Pro 3000 Chime Battery
Change Adt Safewatch Pro 3000 Chime Battery

Next, disengage the backup battery disconnect switch. This switch is usually positioned on the side or bottom of the panel. Use a flathead screwdriver to gently push the switch down and to the right, then up and to the left, effectively disengaging it.

Removing the Old Battery

Using a Philips screwdriver, carefully remove the screws securing the panel's faceplate. Set the screws aside in a safe place. You may need to remove an additional plate to access the battery compartment, depending on your ADT panel model.

How to Remove Adt Touch Panel From Wall
How to Remove Adt Touch Panel From Wall
an alarm remote control is attached to the wall
an alarm remote control is attached to the wall

With the faceplate removed, locate the battery compartment. Gently pull the battery out from the compartment. Be mindful not to damage any of the panel's internal components. If your panel has a battery retainer clip, remember its position as you'll need to reattach it later.

Installing the New Battery

Remove the protective plastic tab from the new battery, ensuring the battery's positive and negative terminals are exposed. Insert the new battery into the battery compartment, aligning the battery's terminals with the corresponding terminals inside the compartment.

AD

If your panel has a battery retainer clip, carefully reattach it to secure the new battery in place. Take care not to over-tighten the clip, as this could damage the battery or battery compartment.

Reassembling and Restoring Your ADT Panel

With the new battery installed, carefully replace the faceplate (and any additional plates you removed earlier). Secure the faceplate using the Philips screws you set aside earlier.

Now, reengage the backup battery disconnect switch. Follow the same procedure you used to disengage it, moving the switch up and to the right, then down and to the left.

AD

Restoring Power to Your ADT Panel

Lastly, restore power to your ADT panel by pressing the 'Ready to Arm' light until the panel displays 'On'. Your panel should now be functioning with its new battery.

To verify that the battery replacement was successful, test your ADT panel's functionalities, such as arming and disarming the system, and check the low battery warning light to confirm it has disappeared.

Replacing the battery in your ADT panel is a simple process that can help maintain your home's security and safety. Always remember to check your battery's status regularly and replace it promptly when necessary. If you encounter any difficulties during the process, don't hesitate to contact ADT's customer support for assistance. Stay safe, and happy DIY!

AD
AD