how to remove submersible well pump

remove submersible well pump: Step-by-Step Guide

By Kevin Thomas
AD

Embarking on a DIY journey to remove your submersible well pump might seem daunting, but with the right steps, it's achievable. Not only does this guide simplify the process, but it also provides safety tips and troubleshooting advice to ensure a smooth operation.

Before delving into the steps, let's understand why you might need to remove your well pump. It could be due to frequent repairs, temporary suspension of water use, or an upgrade to a newer, more efficient model. Regardless of the reason, this guide empowers you to handle the task with confidence.

Preparation: Safety First

Safety is paramount when dealing with water and electrical systems. Start by ensuring the power is off at the main panel, and use a non-contact voltage tester to confirm no electricity is flowing to the well pump circuit.

AD
a man in an orange shirt is working on a pole with some dirt and grass
a man in an orange shirt is working on a pole with some dirt and grass
INSTALL A SUBMERSIBLE WATER PUMP: Lessons for Doing It the Right Way
INSTALL A SUBMERSIBLE WATER PUMP: Lessons for Doing It the Right Way
500FT DEEP! One Person Submersible Well Pump Removal and Installation
500FT DEEP! One Person Submersible Well Pump Removal and Installation

Next, gather your tools: a well brush or stiff-bristled brush, a utility knife, a hammer, a pry bar, plumbing gloves, and a tackle rope or retrieval tool for pulling out the pump.

Isolate and Drain the System

Begin by closing the electricity supply at the main panel. Then, shut off the water supply valve at the storage tank or connected plumbing fixture.

Submersible Pump - Stuck in the Well - 3 Ways it can Happen!
Submersible Pump - Stuck in the Well - 3 Ways it can Happen!

Carefully open the well cap to release the pressure and prevent water from spilling out when the pump is removed. Use a screwdriver or wrench to loosen and remove the well cap. Be cautious, as some water may still flow out.

Retrieve the Pump

Lower the well brush or stiff-bristled brush down the well to clear any debris or obstructions around the pump. This helps in a smoother retrieval process and prevents damage to the pump or cables.

AD

Now, retrieve the pump. Tie the tackle rope or attach a retrieval tool to the pump's frame. Ensure the rope or tool is strong enough to support the pump's weight. Slowly and carefully pull the pump out of the well. Be patient and take breaks to prevent fatigue and potential injury.

Inspect and Modify the Well Pump

Once the pump is out, fully inspect it for any signs of damage. If it's being replaced due to a malfunction, understanding the cause can help preserve the new pump's lifespan.

If you're reinstalling the same pump, clean it thoroughly and check all parts, including the motor, impeller, and piping. If it's being replaced, follow the manufacturer's guidelines for proper disposal of the old pump.

AD

Prepare for Reinstallation or Replacement

Before reinstalling the pump, ensure the well casing is clear and ready. If you're installing a new pump, make sure it's designed to work with your well diameter and depth.

Double-check that the power supply is still off and the wiring is in good condition. For a new pump, carefully run the electrical wires through the impeller area, ensuring they're well-protected and won't cause obstruction.

Always remember to follow local regulations and guidelines when dealing with well pumps and water systems. If, at any point, you feel unsure, consult a professional water well contractor.

AD

Congratulations! You've now removed your submersible well pump, ensuring minimal downtime and maximum safety. This newfound knowledge can help you maintain your well water system more effectively, lowering future expenses and potential issues. Awareness and preparedness are key to successful DIY projects, and this guide primes you for many more such undertakings.

AD