how to remove stuck drum brakes

How to Unlock & Remove Stuck Drum Brakes: Step-by-Step Guide

By Robert King
AD

Nothing can be more frustrating for a vehicle owner than encountering stuck drum brakes. Not only do they pose a safety hazard, but they can also damage your vehicle and wear out other parts of your braking system. Fortunately, you can remove stuck drum brakes at home with the right tools and knowledge. Here's a comprehensive guide on how to do it.

Before you start, ensure your vehicle is on a level surface and securely jacked up. Always engage the parking brake and block the wheels to prevent any unwanted movement. For safety, do not start any work without adequate jack stands or ramps to support the vehicle.

Diagnosing the Issue

Before you start the repair process, it's crucial to identify the cause of the stuck brakes. This could range from lack of lubrication to contaminated brake fluid, physical damage, or even corrosion due to long periods of inactivity.

AD
How to remove a stuck brake drum
How to remove a stuck brake drum
How to Remove a STUCK Drum Brake
How to Remove a STUCK Drum Brake
5 Ways How to Remove a Stuck Brake Drum
5 Ways How to Remove a Stuck Brake Drum

In this guide, we'll focus on the most common cause: lack of lubrication. When your car's brake shoes are not regularly lubricated, they can stick to the brake drum, causing it to seize up.

Gathering the Necessary Tools

To remove stuck drum brakes, you'll need a few basic tools. These include:

5 Ways How to Remove a Stuck Brake Drum
5 Ways How to Remove a Stuck Brake Drum
Stuck Brake Drums - Removal
Stuck Brake Drums - Removal
  • Jack and jack stands or ramps
  • Wrenches (10mm, 14mm, and 17mm, usually)
  • Pliers
  • Screwdriver
  • G majeurs or flathead screwdriver ( depending on your vehicle)
  • Penetrating oil (like WD-40 or PB Blaster)
  • Rubber mallet (small)
  • C Clamp (optional)

Dismantling the Brake Drum

Start by removing the vehicle's tires. Then, using the appropriate wrench, loosen and remove the brake drum. You might need to use a rubber mallet to gently tap the drum counterclockwise to break the rust. If it's still stuck, apply penetrating oil around the drum's circumference and let it soak in for at least 30 minutes to an hour.

In stubborn cases, you can use a c-clamp to gently squeeze the brake drum off. Insert the c-clamp into the drum's inside lip and apply pressure until the drum pops off. Be careful not to damage the brake shoe assembly.

AD

Inspecting and Lubricating the Brake Shoes

Once the drum is off, inspect the brake shoes and hardware. Look for any signs of excessive rust, wear, or damage. If any parts are damaged, they should be replaced.

Using a wrench, remove the brake shoe holddown spring and adjuster. Again, inspect these parts for wear. Reinstall the adjuster with the same number of turns it had earlier. Reassemble the brake shoe mechanism, making sure to lubricate the return springs, shoe holddown, and any moving parts with WD-40 or brake grease.

Reinstalling the Brake Drum

Before reinstalling the brake drum, apply a coat of brake grease around the drum's circumference. This will prevent the drum from seize up again in the future. Line up the drum with the wheel hub and tap it into place using the rubber mallet. Make sure it's fully seated, and the wheel spins freely.

AD

Tighten the drum's holding screw with the appropriate wrench, but do not overtighten. The screw only needs to hold the drum in place, not apply huge pressure. Reinstall the wheel and lower the vehicle.

Take your vehicle for a test drive in an empty parking lot. Apply your brakes a few times to ensure they work correctly and that the wheel spins freely. If the drum still sticks, you may need to repeat the process or seek professional help.

AD