How to Remove WaterPik Reservoir
Are you tired of your Waterpik water flosser not performing at its best due to a clogged reservoir? It's a common issue, but don't worry, removing the reservoir for a thorough clean is actually quite simple. Follow our step-by-step guide to restore your Waterpik to its splashing glory.
Before you start, make sure you have a screwdriver, a bowl, and some warm water with dish soap ready. Also, ensure that your Waterpik is turned off and unplugged to prevent any electrical accidents.
Preparing Your Waterpik
Start by preparing your Waterpik for the reservoir removal process. This involves disassembling the water flosser to reach the reservoir.
First, unscrew the water flosser tip from the handle. Most Waterpik models have a quick-release button that makes this process easy. Just press the button and twist the tip counterclockwise to remove it.
Removing the Reservoir Cover
Once the tip is off, you'll see a plastic cover over the reservoir. This cover is held in place by a small screw. Use your screwdriver to unscrew this, then lift or slide off the cover.
Some Waterpik models may have clips or release buttons instead of screws. If that's the case, simply press the release buttons or slide out the cover.
Accessing the Reservoir
With the cover off, you should now see the reservoir. In some models, the reservoir might not be fully exposed yet, and you'll need to remove a rear panel to access it. This panel is usually clipped or snapped on and can be removed by gently pressing and twisting it.
Other models might have the reservoir directly accessible without needing to remove a rear panel. Always check your Waterpik's user manual for specific instructions if you're unsure.
Cleaning the Reservoir
Now that you've access to the reservoir, it's time to give it a thorough clean. This will help to remove any built-up scale, mold, or mineral deposits that can clog your Waterpik.
First, carefully lift the reservoir out of its holder. Some models might have a tether keeping the reservoir attached to the unit. If yours has one, you can simply lift the reservoir up and out, keeping the tether from getting in the way.
Cleaning the Reservoir in Warm Soapy Water
Fill a bowl with warm water and add a few drops of dish soap. Submerge the reservoir completely in the soapy water, making sure it's fully covered. Let it soak for about 30 minutes to an hour.
After soaking, use a soft-bristled brush or a toothbrush to scrub the reservoir thoroughly. Pay special attention to the base of the reservoir where sediment and mineral deposits tend to build up. Rinse the reservoir well to remove any soap residue.
Descaling the Reservoir (If Necessary)
If your water is hard, you might need to descale the reservoir to remove the mineral buildup. You can use a descaling solution or a mixture of equal parts white vinegar and water. Submerge the reservoir in the solution and let it soak for a few hours or even overnight.
After soaking, use a soft-bristled brush to scrub the reservoir, then rinse it thoroughly. Allow the reservoir to air dry completely before reassembling your Waterpik.
Reassembling Your Waterpik
With the reservoir clean and dry, it's time to put your Waterpik back together.
First, reattach the reservoir to the Waterpik unit. Ensure it's securely in place and the tether (if there is one) isn't tangled.
Replacing the Reservoir Cover
Next, replace the reservoir cover. Line it up properly and snap or screw it back into place. Make sure it's secure and there are no gaps where water could leak.
Lastly, replace the water flosser tip. Remember to use the same type of tip that came with your Waterpik for the best performance. Line up the quick-release button and twist the tip clockwise to secure it.
Your Waterpik is now clean and ready for use. Don't forget to clean the reservoir regularly to keep your Waterpik working at its best. Happy flossing!