How to Remove Knob and Tube Wiring Safely
Discovering knob and tube wiring in your home can be unsettling. This old electrical wiring system, common in homes built between 1880 and 1930, is no longer up to modern safety standards. If you're handy and want to tackle this yourself, here's a step-by-step guide on how to remove knob and tube wiring safely and legally.
Before we dive in, remember: electrical work can be dangerous. Always ensure you comply with local regulations and have a certified electrician inspect and certify your work. It's also crucial to inform your home insurer that you're removing knob and tube wiring.
Planning and Preparation
First, you'll need to assess the extent of the knob and tube wiring in your home. Turn off the electricity at your main panel and use a voltage tester to ensure the wires are dead. Then, map out the routes of the knob and tube wiring.
Next, gather your tools. You'll need a circuit tester, fish tape, pliers, wire strippers, and a reciprocating saw. You'll also need new electrical cable (specifically, non-metallic (NM) cable or armored cable) to replace the old wiring.
Understanding Knob and Tube Wiring
Understanding the components of knob and tube wiring is key to removing it safely. Knob and tube wiring consists of individual wires running through holes in floor joists and wall studs. The wires are secured to the framing with porcelain knobs and supported mid-span with tubes.
There are two types of knob and tube wiring: uninsulated and insulated. Uninsulated wires provide zero protection, while insulated wires have a rubber or fabric jacket. If you're unsure, a voltage tester can help you identify live wires.
Removing Knob and Tube Wiring
Start by cutting the power at the electrical panel. Using a circuit tester, confirm the wiring is dead. Then, carefully remove the porcelain knobs and tubes using a flathead screwdriver or pliers.
Next, use a reciprocating saw to cut through the wall and flooring to expose the wiring. Be cautious not to cut the wires. Once exposed, use fish tape to pull out the old wiring. Be careful not to damage the remaining structure.
Replacing with Modern Wiring
With the old wiring out, it's time to install new electrical cable. First, ensure all open holes in the walls and floors are properly sealed to prevent fire hazards.
Now, install new electrical cable following your mapped-out routes. Remember to follow local electrical codes and regulations. Always use the appropriate size cable for the amperage load. Secure the cable with appropriate boxes, connectors, and staples.
Installing Junction Boxes and Wiring
Install new junction boxes where needed. Make sure they're accessible and safely mounted. Always use appropriate wire connections and make sure connections are tight. Ensure all wires are the correct length and secured properly.
When conducting the final wiring, always use the appropriate wire gauge for the circuit. Again, follow all safety guidelines and local regulations. Ensure your new wiring is appropriately grounded.
Double-Check Your Work
Before restoring power, double-check your work. Ensure all connections are tight, wires are securely stapled, and junction boxes are properly mounted.
Use a voltage tester to ensure there are no short-circuits. It's also a good idea to hire a certified electrician to inspect your work before turning on the power.
Removing knob and tube wiring is a significant project, but it's crucial for your home's safety and resale value. Always prioritize safety and follow local regulations. If in doubt, always consult a professional electrician. Your home will thank you for the upgrade!