how to remove axle seal

How to Remove an Axle Seal: Step-by-Step Guide

By James Jones
AD

Got a vehicle that's leaking gear oil? It's highly likely that the axle seal is to blame. Replacing it might seem daunting, but with the right tools and know-how, it's a doable DIY task. Let's guide you through how to remove an axle seal safely and effectively.

To begin, gather your tools. You'll need a breaker bar, a socket wrench, a universal-type joint separator tool, a pickle fork, an impact wrench, a pry bar, and a mallet. A jack and jack stands are also necessary for lifting your vehicle off the ground.

Preparation: Getting Your Vehicle Ready

Start by disconnecting the negative battery cable to prevent any electrical shorts. Jack up your vehicle and support it securely with jack stands. Ensure the vehicle is stable and won't move during the procedure.

AD
How to Replace Axle Seal in Your Car
How to Replace Axle Seal in Your Car
Replace Axle Seals How To Fix A Leaking Rear Axle
Replace Axle Seals How To Fix A Leaking Rear Axle
Switzerland
Switzerland

Before you start removing any parts, it's a good idea to mark the relationship of the axle and the suspension components. This ensures correct positioning during reassembly.

Draining the Gear Oil and Removing the Driveshaft

Using a suitable container, drain the gear oil from the differential. Once drained, remove the driveshaft. You may need to disconnect or remove suspension components to access the driveshaft bolts. Use penetrating oil to loosen the bolts if necessary.

D44 Axle Shaft Removal and Overhaul - Jeep Wrangler (TJ)
D44 Axle Shaft Removal and Overhaul - Jeep Wrangler (TJ)
How to use a slide hammer to remove an axle bearing
How to use a slide hammer to remove an axle bearing

To disconnect the driveshaft, you'll need a universal-type joint separator tool. This tool expands the joint, allowing the driveshaft to be removed from the axle. Use an impact wrench to break the joint free if needed.

Removing the Axle from the Vehicle

The axle can now be removed from the vehicle. Use a pickle fork or a pry bar to carefully separate the axle from the suspension components. You may need to use a mallet to gently tap the axle out if it's stuck.

AD

Once the axle is out, you'll need to completely remove the leaking axle seal. This is typically done by driving it out with a specialized tool. If you don't have one, you can improvise with a piece of pipe and a hammer, being careful not to damage the axle.

Replacing the Axle Seal: Creating a Perfect Seal

Now that the old seal is removed, clean the seal bore in the axle and differential with a wire brush to remove any debris or rust. Ensure the bore is smooth and clean to prevent leaks.

AD