how to remove a mortise lock cylinder

How to Remove a Mortise Lock Cylinder

By Mark Martin
AD

Removing a mortise lock cylinder is a common task when replacing a lock or performing routine maintenance. This process involves careful dismantling of the lock mechanism without causing any damage. Here's a step-by-step guide to help you through this procedure.

Before we dive in, it's crucial to have the right tools. You'll need a Flathead screwdriver, a Lock cylinder removal tool, an Adjustable wrench, and some patience. Make sure the area is well-lit and clear of obstacles for safety and convenience.

Understanding the Mortise Lock Cylinder

A mortise lock cylinder is a component of a mortise lock, a type of lock that is embedded into a pocket, or mortise, in a door. The cylinder is the part of the lock that the key interacts with, turning the plug and ultimately unlocking or locking the door.

AD
How To Remove a Mortise Cylinder Lock Set From an Entrance Door
How To Remove a Mortise Cylinder Lock Set From an Entrance Door
How to Remove and Repair a Mortise Door Lock
How to Remove and Repair a Mortise Door Lock
How to remove the lock cylinder from a Kwikset SmartKey entry knob
How to remove the lock cylinder from a Kwikset SmartKey entry knob

To remove the cylinder, you'll need to separate it from the lock mechanism. The process can vary slightly depending on the brand and type of lock, but we'll outline a general procedure that should work for most standard mortise locks.

Preparing the Lock

First, you need to remove any screws or set screws that are holding the mortise lock faceplate in place. These are usually found on the edge of the lock where it meets the doorframe. Use your Flathead screwdriver to carefully remove these screws.

How to Rehand Mortise Lockset
How to Rehand Mortise Lockset
How To Cut Down Metal Residential Doors - Hunker
How To Cut Down Metal Residential Doors - Hunker

Once the screws are out, the faceplate should be loose but still attached to the lock mechanism. Do not remove the faceplate yet; it's staying in place to act as a guide for the removal tool.

Removing the Cylinder

Now, insert the lock cylinder removal tool into the keyway at the end of the cylinder. This tool is designed to engage with the retention spring in the cylinder, allowing you to pull it out.

AD

If your lock doesn't have a removal tool, you can improvise using a thin, flat piece of metal or a strong wire. However, be extremely careful not to damage the retention spring in this case.

Removing the Retained Plug

The retained plug refers to the part of the lock cylinder that the key enters. It's held in place by a retention spring, which prevents it from falling out when the door is opened.

Once you've engaged the removal tool with the retention spring, use gentle but firm pressure to push the tool towards the back of the lock. As you do this, you should feel the plug pop out slightly. This is the retention spring releasing.

AD

Pulling Out the Cylinder

With the retention spring released, you can now pull the cylinder straight out of the lock. Be careful not to twist or turn the cylinder as you pull. If you feel any resistance, gently rock the cylinder back and forth to disengage it from the lock mechanism.

After successfully removing the cylinder, you should inspect it to ensure it's in good working order. If you're replacing it with a new cylinder, make sure the new one matches the exact dimensions and style of the old one to ensure a proper fit.

Replacing the Cylinder

If you're replacing the cylinder, align the new one with the opening in the faceplate and start to gently push it back into the lock mechanism. You'll feel it click into place when the retention spring engages.

AD

Once the new cylinder is fully seated, reattach the faceplate and secure it with screws. Test the lock to ensure everything is working correctly before securing the area.

In most cases, removing a mortise lock cylinder is a straightforward task that requires patience and the right tools. If you're unsure at any point, don't hesitate to consult with a professional locksmith.

AD