how to rebuild a 46re transmission

Step-by-Step Guide: Rebuilding a 46RE Transmission

By Joshua Hernandez
AD

Tackling a 46RE transmission rebuild might seem daunting, but with the right approach and understanding, it's an achievable task for your garage or workshop. Here, we'll break down the process into manageable steps, ensuring a successful outcome and a smooth-running Ford truck or van.

Before you dive under the hood, ensure you've gathered all the necessary tools and replacement parts. Gather your engine hoist, transmission jack, jack stands, drain pan, SAE transmission fluid, new Transmission Seals Kit, and other required components.

Disassembly and Inspection

Begin by safely lifting and securing your vehicle on jack stands. Allow the transmission to cool and drain all the fluid into a clean drain pan.

AD
How to Rebuild BorgWarner Transmissions
How to Rebuild BorgWarner Transmissions
Everything You Need To Know About Rebuilding A 4L80E Transmission
Everything You Need To Know About Rebuilding A 4L80E Transmission
How to Start a Ford Transmission Rebuild Project: C4 and C6
How to Start a Ford Transmission Rebuild Project: C4 and C6

Disconnect the output shaft speed sensor, reverse lights switch, and drive shaft. Remove the transmission dipstick, cooler lines, and torque converter. Support the transmission with a transmission jack and carefully lower it from the vehicle.

Removal of the Torque Converter

With the transmission out, you'll need to remove the torque converter. Use a transmission jack and an appropriate puller tool. Be mindful of the delicate seal ring during this process.

Introduction to Rebuilding GM/Muncie 4-Speed Transmissions
Introduction to Rebuilding GM/Muncie 4-Speed Transmissions
Why You Should Rebuild a Transmission vs Buying Used [Quick Guide]
Why You Should Rebuild a Transmission vs Buying Used [Quick Guide]

Once separated, inspect the converter's internal components. Check the stator for play or excessive wear. Inspect the turbine and pump for any visible damage or cracks.

Transmission Case Disassembly

Position the transmission case on a suitable workbench or transmission stand. Remove the case bolts and carefully separate the two halves. Keep track of the location of each gasket and seal for reinstallation.

AD

Remove the planetary gear sets, clutch packs, and other internal components. Inspect each part thoroughly for wear, damage, or signs of failure. Make note of any parts that need replacing.

Internal Cleaning and Inspection

After disassembly, clean all internal components using a suitable solvent and lint-free rags. Inspect the synchronizer rings, bushings, and other wear items for signs of excessive wear or damage.

Check the valve body and ensure all valves and springs are functioning correctly. Replace any faulty components and install a new valve body gasket.

AD

Purchase and Installation of New Components

Based on your inspection, gather new or re-manufactured components as required. This may include clutches, bands, gears, or seals. Ensure you're using high-quality, OEM-approved parts.

Reinstall the new components following the reverse procedure of disassembly. Ensure each part is correctly positioned and properly lubricated using the recommended transmission fluid.

Transmission Reassembly

Begin by reinstalling the main case's internal components. Ensure each component is properly lubricated and mated correctly. Reinstall the desired shifter and pivot balls, and the reverse light switch.

AD

Reassemble the torque converter, making sure to replace the seal ring. Reinstall the transmission onto the engine, using a transmission jack to ensure proper alignment and secure attachment.

Final Installation and Adjustments

Reattach all transmission mount bolts, cooler lines, and fill the transmission with the recommended amount of SAE transmission fluid.

With the vehicle securely supported, remove the jack stands and start the engine. Check for leaks and ensure the transmission shifts smoothly through all gears. Perform a test drive, monitoring the transmission's performance and temperature.

After completing the test drive, top off the transmission fluid and perform any necessary adjustments. Now, your 46RE transmission should be running smoothly, ready to provide reliable service for years to come. Regular maintenance and prompt attention to any potential issues will help ensure its longevity. Happy wrenching!

AD