how to reattach body side molding

Reattach Body Side Molding: Step-by-Step Guide

By Kevin Jackson
AD

Rippled, peeled, or detached body side moldings can significantly diminish your vehicle's aesthetic appeal. Fear not, as you can effortlessly restore its sleek appearance by learning how to reattach body side molding. This article will guide you through a step-by-step process, ensuring a professional finish that's sure to revamp your ride's curb value.

Before we dive into the repair process, let's understand what body side moldings are. These are decorative trims that run along the sides of your vehicle, serving both functional and aesthetic purposes. They protect the vehicle from minor scuffs and scratches while accentuating its contours. Now, let's delve into reattaching these crucial components.

Preparation and Gathering Tools

Reattaching body side moldings requires the right tools and a clean workspace. Equip yourself with the following:

AD
How to Reattach Molding on a Car Door
How to Reattach Molding on a Car Door
How Do I Reattach Body Side Molding?
How Do I Reattach Body Side Molding?
a man waxing the side of a car with a yellow cloth on it's handle
a man waxing the side of a car with a yellow cloth on it's handle

  • Plastic trim remover
  • Plastic trim adhesive
  • Hair dryer or heat gun
  • Masking tape
  • Scissors or utility knife
  • Microfiber cloths
  • Body side molding

How to Reattach Molding on a Car Door
How to Reattach Molding on a Car Door
’77 C10 | Installing Mar-K’s Body-Side Molding
’77 C10 | Installing Mar-K’s Body-Side Molding

Cleaning the Surface

Before applying any adhesive, the surface must be clean and free of dirt, grease, or other contaminants. Use mild soap and water, or a specialized vinyl cleaner to prepare the area.

Priming the Surface

After cleaning, dry the area thoroughly. Apply a thin layer of primer to enhance the bond between the surface and the adhesive. Allow it to dry according to the manufacturer's instructions.

AD

Reattaching the Body Side Molding

Now that the surface is primed and ready, it's time to reattach the body side molding. Follow these steps for a seamless process:

Heating the Molding

Use a hair dryer or heat gun to warm the molding. Heat makes the plastic more pliable, enabling it to conform to curves more easily. Be cautious not to overheat, as this can damage the plastic.

Applying the Adhesive

While the molding is warming, apply the adhesive to the backside of the molding, following the manufacturer's guidelines. Ensure even coverage without applying too much, as excess adhesive can ooze out and create a mess.

AD

Aligning and Pressing

Position the molding along the vehicle's body line. Use masking tape to temporarily hold the molding in place. Press against the molding to ensure it adheres firmly to the vehicle's surface. Hold in place for the time specified in the adhesive's instructions.

Trimming and Finishing

Once the adhesive has set, carefully remove the masking tape. If any excess adhesive has seeped out, use a utility knife and microfiber cloths to clean it up. Trim any excess molding using scissors or a utility knife if necessary.

Reattaching body side molding can seem daunting at first, but it's a manageable task when armed with the right knowledge and tools. Remember, patience and meticulousness are key to achieving a flawless finish. Happy repairing!

AD
AD