how to put a string on a yoyo

How to String a Yoyo: The Ultimate Guide

By Sarah Young
AD

Experience the timeless joy of yoyoing by mastering the art of putting a string on a yoyo. This simple task opens doors to endless tricks that have captivated enthusiasts for generations. Let's dive into a comprehensive guide, ensuring your yoyo is always ready for action.

First, gather your yoyo and a new or replaced string. A quality yoyo string, typically made of weighted polyamide or cotton, is crucial for optimal play. You'll also need a yoyo string cutter to ensure clean ends.

Preparing Your Yoyo and String

Begin by ensuring your yoyo is clean and free of residue. A slight lubricant application can enhance spin time, but avoid excess lubricant which may attract dirt.

AD
How to Put a String on a Yoyo and Adjust it for Play
How to Put a String on a Yoyo and Adjust it for Play
Learn how to Replace a Yoyo String
Learn how to Replace a Yoyo String
How to Make Yo-Yo String
How to Make Yo-Yo String

Next, examine your string. Stretch it gently to remove any coil memory. Cut both ends of the string to approximately 44-46 inches (113-117 cm) for a standard yoyo. This length allows for optimal playing, trimming excess string while ensuring enough length for wrapping.

Threading the String through the Yoyo

Locate the hole in your yoyo's axle. Insert one end of the string into this hole. Ensure the string is centered within the yoyo's axle before pulling it through.

Adjust the yoyo string for your height
Adjust the yoyo string for your height
Elevator Yoyo Trick - Learn How
Elevator Yoyo Trick - Learn How

Gently pull the string through until about 1 inch (2.5 cm) of string remains on one side. This initial pass secures the string, preventing it from pulling back through the yoyo.

Tying the String to the Yoyo

A secure knot is essential for preventing the string from slipping off. Use either a Lark's Head knot or an Overhand knot, as these are most reliable for yoyo strings.

AD

To tie a Lark's Head knot, insert the string back into the hole and pull it through until both ends are on the same side. Wrap the string around the yoyo's axle, then tie it using an Overhand knot. Ensure the knot is pulled tight against the yoyo's axle for maximum security.

Tying the Slider Knot

A Slider knot provides tension for yoyo tricks and helps instringing and outstringing. Tie this knot about 2 inches (5 cm) from the end of the string.

To create a Slider knot, make a loop in the string, placing the loop on the side where the yoyo will hang. Cross the two string ends, and tie an Overhand knot, pulling it tight against the loop. Adjust the knot to balance the tension between the two string ends.

AD

Trimming Excess String

After tying the Slider knot, trim the excess string to your desired length. Most players trim the string to around 1/2 to 3/4 inches (1.3 to 1.9 cm) above the knot, allowing enough length for various tricks.

Use a yoyo string cutter to ensure clean, smooth ends. After trimming, gently pull on the string to remove any remaining coil memory, and you're ready to yoyo!

Embracing the art of yoyoing begins with mastering the fundamentals. By learning how to put a string on a yoyo, you're equipped to explore an array of tricks and techniques. Happy yoyoing!

AD
AD