Mastering Reel Fishing: A Simple Guide on How to Put a Line on a Spinning Reel
Are you a fishing enthusiast looking to switch from a conventional reel to a spinning reel but uncertain about how to put a line on? No worries! With a bit of patience and the following step-by-step guide, you'll be ready to cast a line and catch your first fish in no time. Here's how you can properly spool a spinning reel with ease.
Before we dive into the process, ensure you have the right equipment: a spinning reel, a spool of fishing line, and a pair of scissors. We'll guide you through the process using a monofilament line, but the steps are similar for braided and fluorocarbon lines.
Preparing Your Spinning Reel
Begin by removing the reel from your fishing rod, if it's already attached. You can do this by unscrewing and pulling it off. Next, open the bail (wire arm) by flipping it back. This will give you better access to the spool.
Now, remove the reel's protective cap or hood installed during manufacturing. You might need to pry it off gently using a flathead screwdriver. If there's an O-ring, retain it for later use.
How to Determine the Optimal Line Capacity
Reel manufacturers usually print a line capacity chart on the reel's body. Find this chart to help you decide on the line strength and length suitable for your reel. For example, a reel designed for 10-30 lb test line might accommodate 160-280 yards of 10 lb line or 120-220 yards of 30 lb line.
Use these guidelines to estimate how much line you'll need. A common recommendation is to spool the reel with enough line to fill it up to the designated distance markers, usually 1/8th to 1/4th of an inch from the spool's outer lip.
Prepare the Fishing Line
Now, measure and cut your fishing line to the desired length. Start with a longer piece, as you can always trim it later. Tie a small barrel swivel to one end of the line using a Palomar knot. This knot is efficient and can be easily tied.
Lubricate the swivel with some reel grease to facilitate smooth line transfer during the spooling process. Leave about 6-8 inches of line on the other end of the swivel for attaching your lure or leader later.
Spooling the Line onto Your Reel
Secure the reel in a vice or clamp to keep it steady during the spooling process. Hold the free end of the line with your index finger, preventing it from unraveling.
Begin spooling the line by placing the tag end (the end tied to the swivel) onto the spool and wrapping it two or three times around the spool near the flat edge (the side you'll cast from). This creates a base for the rest of the line to lie on while winding.
Spooling from the Base
Start winding the line onto the reel, keeping your index finger on the spool to apply pressure and maintain a uniform tension. Keep the line on the outer lip of the spool and work your way inwards. This makes casting easier and prevents line tangles.
Periodically check the line's presentation on the spool to ensure it's lying straight and has no twists. If you notice any, stop winding and straighten the line before continuing.
Finishing Up
After spooling the desired amount of line, hold the reel up to check if it reaches the designated line capacity mark. If it does, snip off the excess line at the start of the spool (close to the base you created).
Remove the reel from the vice and flip the bail back into place. A slight backpressure on the line should allow it to close. Now, you're ready to attach a lure, bait, or leader and test your line with a practice cast.
Pro tip: Always store your fishing reel with the line open and the bail closed, protecting the line from damage and wear during storage.
And there you have it! You've successfully spooled your spinning reel with a new line. Now, it's time to hit the water and test your new setup. Happy fishing!