how to program an onn remote

Mastering ONN Remote Programming: A Comprehensive Guide

By Michael Walker
AD

Are you tired of fiddling with your ONN remote every time you want to switch channels? Wish you could program it to remember your favorite shows? You're not alone. Many people struggle with programming their ONN remotes, but we're here to help. In this comprehensive guide, we'll walk you through the steps to program your ONN remote in an easy-to-understand manner.

Before we dive in, let's clarify that while we're using the term 'program', it's more about teaching your remote certain commands rather than coding in the traditional sense. So, let's get started!

Identifying Your Device Code

First, you need to find the device code for your TV. This is a 3 or 4-digit code that's usually located in your TV's manual or on the manufacturer's website. Some common ONN codes include 0066, 0101, and 0150, but it's best to double-check.

AD
Programming This ONN 6 Device Universal Remote to ANY Device!
Programming This ONN 6 Device Universal Remote to ANY Device!
Programming This ONN 4 Device Remote to YOUR Devices!
Programming This ONN 4 Device Remote to YOUR Devices!
Onn Universal Remote Codes: Program ONB13AV004 for 4 Devices
Onn Universal Remote Codes: Program ONB13AV004 for 4 Devices

If you can't find your code, try looking for a model number or serial number on your TV. The device code should be listed under that model on the ONN website. Alternatively, you can try the universal code, which is 0150, and see if it works.

Preparing Your Remote

Before you begin, make sure your remote is set to control your TV. If it isn't, press the 'TV' button on your remote (it might be labeled 'TV' or have a TV icon). Then, press and hold the 'SETUP' button until the LED light at the top of your remote starts blinking. This indicates that your remote is in learning mode and ready to accept new codes.

How To Program A Chunghop Universal Remote Control - Codes For Universal Remotes
How To Program A Chunghop Universal Remote Control - Codes For Universal Remotes
Easy RCA Remote Setup — No Code Required! Universal TV Remote Tutorial
Easy RCA Remote Setup — No Code Required! Universal TV Remote Tutorial

Entering the Device Code

Now that your remote is in learning mode, you can enter your device code. Here's how:

  1. Using the number keys, enter the device code you found earlier. For example, if your code is 0150, you would press 0, then 1, then 5, then 0.
  2. After entering the code, press the 'CH+' button. If the LED light on your remote turns off, that means the code was accepted and your remote is now programmed. If the light continues to blink, that means the code was not accepted and you'll need to try again.

Testing Your Remote

To check if your remote is working, try changing the channel or turning the TV on and off. If your remote responds to these commands, that means it has been successfully programmed. If not, you may need to repeat the steps above with a different device code.

AD

Adding Additional Devices

If you want to program your remote to control more than one device, you can do so by following the same steps mentioned above. Just make sure to switch to the correct device mode ('TV', 'AUDSYS' for audio systems, etc.) before entering the new code.

Using the Mode Button

To switch between devices, use the 'MODE' button on your remote. This button is usually labeled with a TV or a satellite dish icon. Pressing this button will cycle through the different device modes. For example, one press might switch you to TV mode, the next to AUDSYS mode, and so on.

To change the device mode without switching to a different device, press and hold the 'MODE' button for 5 seconds. This will cycle through all the modes and end up back at the starting point.

AD

And there you have it! With these steps, you should now be able to program your ONN remote to control your TV and any other devices you want. Happy streaming!

AD