how to ohm out a contactor

How to Ohm Out a Contactor: Step-by-Step Guide

By Anthony Jackson
AD

Contactor malfunctions can disrupt your electrical circuits and equipment, leading to downtime and potential damage. Ohming out, or testing a contactor's integrity using an ohmmeter, is a crucial step in troubleshooting these issues. This process helps identify blown fuses, blown coils, or shorted contacts. Here, we'll guide you through the process, from preparation to interpretation of results.

Before we dive in, ensure you have the right tools: an ohmmeter, a multimeter, gloves, and safety glasses. Remember, safety first when working with electrical components. Always turn off power and ground yourself before starting.

Preparation: Understanding Contactors

A contactor is essentially an electrically controlled switch used for switching power to heavy or inductive loads. They consist of a coil, which triggers the switch, and the switch itself, which can be normally open (NO) or normally closed (NC).

AD
How to Wire a Contactor Latching Circuit | Easy Motor Start Stop Wiring Explained
How to Wire a Contactor Latching Circuit | Easy Motor Start Stop Wiring Explained
How to connect a magnetic starter with a motor.
How to connect a magnetic starter with a motor.
What is Electrical Contactor? Types of Magnetic Contactors
What is Electrical Contactor? Types of Magnetic Contactors

To ohm out a contactor, we'll focus on testing the coil and the contacts separately. The coil controls the contacts, so a faulty coil can render your contactor inoperable. Similarly, damaged contacts can causeThe first step in ohming out a contactor is understanding its internal components. A typical contactor consists of a coil and set of mechanical contacts. The coil, when energized, creates a magnetic field that engages the contacts. The contacts can be of two types: normally open (NO) and normally closed (NC). NO contacts complete a circuit when energized, while NC contacts break the circuit when energized. a short circuit or open circuit, leading to system failure.

Testing the Coil

Start by testing the coil. Normally, the coil resistance should fall within the specified range on the contactor's data sheet, typically around 1 to 10 ohms. Set your ohmmeter to its lowest ohms setting.

What is a Magnetic Contactor?
What is a Magnetic Contactor?
How to Connect EHC15A Digital Time Switch with Contactor, Button, and Light.
How to Connect EHC15A Digital Time Switch with Contactor, Button, and Light.

To test, connect one probe to each coil terminal. You should see a reading within the coil's allowed range. If the reading is infinity, your coil is open. If it's too low (e.g., below 1 ohm), your coil is shorted. Record these readings for reference during your repairs.

Testing the Contacts

The contacts can be more complex to test. First, ensure your contactor is de-energized. Then, test each contact point with the ohmmeter set to its lowest ohms setting. For NO contacts, there should be infinite resistance when de-energized, and near zero when energized. For NC contacts, the opposite is true.

AD

Record these readings as well. If there's no change in resistance with energizing or de-energizing, your contacts are likely stuck or damaged.

The Importance of Regular Testing

Regular ohming out of contactors can prevent issues from spiraling out of control. By catching problems early, you can save time, money, and equipment. It's part of a routine maintenance plan that can extend the life of your electrical systems.

Moreover, it's not just about preventing downtime. Regular testing can also help ensure safety. Faulty contactors can cause sparks, heat, or even fires. Keeping your equipment in good repair keeps your workplace safe.

AD

So, don't let electrical issues sneak up on you. Make ohming out your contactors a routine part of your maintenance schedule. Your equipment, your team, and your bottom line will thank you.

AD