Effortless Deck Raising: How to Jack Up a Deck in 5 Steps
Is your deck sagging or uneven, making it unsafe or uncomfortable to use? Don't panic, you can fix this by jacking up your deck. This process involves lifting your deck with a jack and supporting it temporarily to repair or level it. Here's a comprehensive guide on how to jack up a deck, ensuring safety and stability.
Before you start, ensure you have the right tools and equipment. You'll need a bottle jack or scissor jack, suitable jack stands, safety glasses, gloves, and screws or nails. Also, check the weather forecast to ensure you'll be working in dry conditions.
Preparation and Safety
Safety is paramount when working with heavy equipment and structures. Begin by ensuring there's no one else around and that kids and pets are kept away from the work area.
Next, inspect your deck to locate the joists - these are the horizontal beams that run from the house to the outer edge of the deck. These are where you'll place your jacks. Make sure the ground beneath these joists is stable and can support the weight of the jack and the deck.
Jack Selection and Positioning
Select a jack that's rated to lift at least 6,000 pounds, as a typical deck can weigh up to 5,000 pounds. A bottle jack or a scissor jack should suffice. Position the jack under the center of a joist, near the house edge of the deck. This will give you the most stability and control when lifting the deck.
Securing the Jack
Once the jack is positioned, start lifting the deck slightly using the jack's handle. Only lift the deck about an inch at a time, and be careful not to lift it too high - you don't want to lift it so high that the weight becomes too much for the jack or the house to support.
Secure the jack in place using nails or screws. Drive one nail or screw into the jack's top plate and another into the joist to prevent the jack from sliding or moving while supporting the deck.
Lifting the Deck and Supporting
With the jack securely in place, start lifting the deck in small increments. As you lift the deck, place a jack stand under the deck, close to where you're lifting it. Ensure the stand's base is stable and level on the ground, and the top is flat and solid.
Once you've lifted the deck high enough for the stand to fit under it, stop lifting and place the stand's top under the deck. Slowly lower the jack until the deck is resting on the stand. Repeat this process until you've lifted and supported all the sagging or low portions of the deck.
Checking for Level
Once you've lifted and supported the entire deck, use a level to check if the deck is flat and even. This is crucial, as you want to ensure that the deck is level before you make any permanent repairs or adjustments.
If there are still high or low spots, you can adjust the jacks and stands to level the deck. Be patient and make small adjustments at a time - rushing can lead to instability or further damage.
Making Repairs and Permanently Support the Deck
With the deck level and stable, you can now make any necessary repairs. This could include Sistering (attaching additional joists to strengthen weak ones), replacing rotted wood, or adding permanent supports.
Before you lower the deck, ensure all your repairs are complete and that the deck is fully supported. This could mean adding additional supports under the deck, or even reinforcing the house structure where the deck is attached.
Once you're satisfied with your repairs, carefully lower the deck back to its original position. Remove the jacks and stands, and enjoy your newly repaired, level deck.
Regularly inspect your deck for signs of sagging, warping, or rotting. Early detection and maintenance will help prevent the need for jacking up your deck in the future. Happy DIYing!