how to install refrigerator end panel

Step-by-Step Guide: How to Install Refrigerator End Panel

By Ashley Wilson
AD

Installing a refrigerator end panel might seem daunting at first, but with the right guidance, it's a task that can be accomplished with ease. Not only will this add a stylish touch to your kitchen, but it also enhances safety by concealing the refrigeration components. Let's dive into a step-by-step guide on how to install your refrigerator end panel.

Before we begin, ensure you have the following tools on hand: a #2 Phillips screwdriver, a level, a tape measure, and a pencil. Also, make sure your new end panel is the correct size and style for your refrigerator model.

Preparation

Before you start, locate the existing end panel bracket. This is usually a vertical piece of metal at the back of your refrigerator, towards either the left or right side.

AD
How to Build a Refrigerator Cabinet - Plank and Pillow
How to Build a Refrigerator Cabinet - Plank and Pillow
Installing refrigerator end panels
Installing refrigerator end panels
three pieces of plywood are laying on the floor in preparation for being installed to the ceiling
three pieces of plywood are laying on the floor in preparation for being installed to the ceiling

Measure the height and width of this bracket to ensure your new end panel will fit perfectly. Also, take note of the design of the bracket - some are flat while others have a contoured shape.

Removing the Old End Panel

First, unplug your refrigerator from the power source to ensure safety.

an empty kitchen with the words, this looks cheap on it's door and cabinets
an empty kitchen with the words, this looks cheap on it's door and cabinets
Hidden Refrigerator DIY with Panelling
Hidden Refrigerator DIY with Panelling

Using your #2 Phillips screwdriver, remove the screws that hold the old end panel in place. Typically, there are four screws, two at the top and two at the bottom. If your refrigerator has another type of bracket, follow the same process but adapt it to your specific bracket design.

Installing the New End Panel

Before installing the new panel, compare it to the bracket to ensure it will fit precisely. If needed, trim the panel using a utility knife or saw to achieve the perfect size.

AD

Hold the new end panel up to the bracket, ensuring it's level. Mark the panel where the screws will go using a pencil.

Securing the End Panel

Start by placing the new end panel against the bracket, ensuring that it's perfectly level both horizontally and vertically. Use the marks you've made as a guide to drill new pilot holes into the end panel.

Insert the #2 Phillips screws through the pilot holes and into the bracket. Tighten them securely but not overly tight, as this could cause the end panel to warp or crack.

AD

Testing the Install

Once the end panel is securely attached, plug your refrigerator back in. Open the refrigerator door and ensure that the end panel is not interfering with its opening or closing mechanism.

Give your refrigerator a few hours to run, then check the temperature to ensure everything is functioning as expected. If there are any issues, double-check your installation and consult your refrigerator's manual if necessary.

Congratulations! You've successfully installed your refrigerator end panel. Remember, proper installation ensures smooth operation and a longer lifespan for your appliance. Now, you can enjoy a safer, stylish, and well-functioning kitchen.

AD
AD