How to Install Furrion Backup Camera: Step-by-Step Guide
Installing a backup camera, especially one from the renowned Furrion brand, can significantly enhance your vehicle's safety by providing valuable rear view visibility. This step-by-step guide will walk you through the process, ensuring you achieve a professional-level installation. Remember, safety first, so always disconnect your vehicle's battery before beginning any electrical work.
Before we dive into the installation process, let's ensure you have the right tools and components. You'll need a Furrion backup camera system, a 16 AWG power wire, a 18 AWG video cable, a drill with the appropriate bit for your vehicle's make and model, and various hand tools including screwdrivers, wire strippers, and electrical tape.
Preparation: Wiring and Power
The first step is to run the power wire and video cable from the backup camera to your vehicle's reverse lights. This will ensure the camera only operates when your vehicle is in reverse. Use the provided power wire and video cable, or if necessary, extend them with appropriate gauge wires.
Next, strip about 1/2 an inch of insulation from both ends of the power wire and video cable. Using electrical tape or heat shrink tubing, seal the exposed wires to prevent corrosion and moisture intrusion.
Power Wire Connection
Identify your vehicle's reverse light power wire, usually red or brown, and connect one end of the power wire to it. Ensure you make a secure, waterproof connection using crimping or soldering. For added safety, use a fuse to protect the wire from overcurrent situations.
Route the wiring neatly along the vehicle's frame or interior, keeping it away from moving parts and high-temperature areas. Use wire loom or cable ties to secure the wires in place.
Video Cable Connection
Locate the reverse lights' ground wire, usually black or white. Connect one end of the video cable's outer shield to this ground wire. Then, connect the video cable's inner wire to the reverse light's power wire, near where you connected the power wire for the backup camera.
Ensure both connections are secure and insulated to prevent any signal interference or short circuits.
Camera Mounting and Positioning
Before drilling any holes, determine the best position for your Furrion backup camera. most vehicles have a suitable spot near the license plate or on the rear bumper. Ensure the camera is centered and has a clear view of the area behind your vehicle.
Once you've found the ideal spot, use a marker to outline the camera's mounting points. Then, using a drill with the appropriate bit, create mounting holes for the camera bracket. Be sure to wear safety glasses and work in a well-ventilated area when drilling.
Mounting the Camera
Position the camera bracket over the mounting holes, aligning the screw holes with the drilled holes. Secure the bracket in place using the provided screws. Ensure the camera is mounted securely and at the correct angle to provide a clear view of the rear area.
Connect the video cable and power wire to the Furrion backup camera, ensuring wires are properly routed and secured. Again, use electrical tape or heat shrink tubing to seal any exposed wires.
Testing the Backup Camera
Reconnect your vehicle's battery. Turn the ignition to the 'ON' position but do not start the engine. Engage the reverse gear. Your backup camera should now be active, displaying the rear view on your vehicle's monitor or infotainment screen.
Adjust the camera angle if necessary to ensure you have a clear, unobstructed view of the area behind your vehicle. Once you're satisfied with the view, secure any loose wires and doubly ensure all connections are tight and waterproof.
Congratulations! You've successfully installed your Furrion backup camera. This system not only enhances your vehicle's safety but also boosts its functionality and aesthetics. Regularly test your camera to ensure it remains in good working order, and never hesitate to contact Furrion's customer support if you encounter any issues or need further assistance.