**Step-by-Step: Installing Bali Blinds Using the Inside Mount Method**
Installing Bali blinds inside mount can significantly enhance the aesthetic appeal of your windows. An inside mount installation allows your blinds to blend seamlessly with your window frame, creating a polished, seamless look. Here's a comprehensive guide to help you achieve a professional finish.
Before you begin, gather all necessary tools and materials. You'll need a tape measure, utility knife, pencil, screwdriver, drill, drill bit, and of course, your Bali blinds. Ensure you have the right size blinds for your window by measuring width and height accurately.
Preparing Your Window
An inside mount requires that your window frame is deep enough to accommodate the blinds. Measure the depth of your frame to ensure it's at least 2 inches deep. If not, you may need to reconsider your installation or adjust your blinds accordingly.
Remove any existing window hardware or obstructions that could hinder the new blinds installation.
Measuring for Precision
Accurate measurement is key to a perfect fit. For inside mount, measure the width at the top of the window frame, where the blind headrail will sit. Note the smallest measurement, as there should be a 3/16" to 1/4" space on either side of the blind to allow for easy operation.
Measure the height of the window on both sides. The blind should start around 3/16" above the bottom of the window for a neat, tuck-away look. Record the smallest measurement for the blind's height.
Installing the Headrail
Once you have your blinds, mark the furniture holes (usually 2" to 2.5" from the ends of the headrail) on your window frame using a pencil. Drill pilot holes slightly smaller than your screw size to prevent the screws from stripping.
Position the headrail into place, align the pilot holes with the marks, and secure it with screws. Ensure the headrail is level and centered. Tighten the screws gently to avoid stripping the holes or damaging the headrail.
Installing the Valance (if included)
If your Bali blinds kit comes with a valance, measure the width and mark the position on your window frame. Most valances are designed to fit inside the window frame, but some might be installed outside. Follow the kit's instructions for your specific valance.
Position the valance, mark the holes, and drill pilot holes. Secure the valance with screws, ensuring it's level and centered. Some valances might require additional hardware for support.
Installing the Blind Slats
Unroll the blind slats from the headrail. For Bali blinds, tilt the slats by turning the wand towards you to fully extend and engage the slats. Check that all slats are level and operating smoothly.
Lower the blind to the desired height. Typically, blinds should cover the entire window area below the headrail. Adjust the cord lightly as you lower the blind for a even descent. Securely tie the cord anchors, ensuring cords are taut for smooth operation.
After installation, check your blinds regularly to ensure they're operating smoothly and the hardware is secure. Enjoy your new Bali blinds!