how to install a larson storm door closer

Mastering Larson Storm Door Closer Installation: Step-by-Step

By Nicole Walker
AD

Are you tired of dealing with a lagging storm door? A Larson storm door closer can solve your woes, securing your door and enhancing its functionality. This guide will walk you through a step-by-step process on how to install a Larson storm door closer, ensuring a safe and effective operation.

Before you proceed, ensure you're equipped with a Phillips screwdriver, drill, measuring tape, pencil, and the Larson storm door closer kit.

Inspecting the Door and Closer Kit

Begin by inspecting the storm door and the closer kit. Identify the strike plate on the storm door frame and ensure it's centered and functional. The closer kit should include an arm, bracket, spring, and a set of screws.

AD
How to install a storm or screen door closer
How to install a storm or screen door closer
How To Install The LARSON 159 Hidden Closer Storm Door
How To Install The LARSON 159 Hidden Closer Storm Door
How to Install a Door Closer
How to Install a Door Closer

Label the screws based on their size to avoid confusion during installation. Ensure all components are clean and free from any kind of debris.

Marking and Measuring for the Closer Bracket

Open the storm door fully and locate the hinge pin. Measure 6" to 9" downwards from the hinge pin. This measurement should fall within the recommended range for most Larson storm door closers. Mark this point on the door, as this will be where the closer bracket is installed.

How to Install a Storm Door Closer
How to Install a Storm Door Closer
How-to Install a QuickFit Handle set on a LARSON door
How-to Install a QuickFit Handle set on a LARSON door

Drilling the Pilot Hole

Using a drill bit slightly smaller than the screw you'll use, drill a pilot hole at the marked point. This will make it easier to insert the screw and prevent the wood from cracking.

Ensure the drill bit is perpendicular to the door surface for a clean, straight hole. If you have a door stop, be cautious not to drill through it.

AD

Securing the Closer Bracket

Take the closer bracket and align it with the pilot hole. Ensure the bracket's arm can freely move once installed. Use your labeled screws to secure the bracket to the door. Tighten gently, using a screwdriver, to avoid stripping the screws.

Check that the bracket is fully secure and that the arm can move freely. If it's too tight, loosen the screws a bit.

Installing the Closer Arm and Spring

The closer arm should be aligned with the bracket arm. Carefully slide it onto the bracket. The spring should be attached to the closer arm, under the hole where the pin will go.

AD

Aligning the Closer Arm and Spring

Position the closer arm so that it hangs vertically and the spring is fully extended. Check that the arm can still move freely. If it can't, adjust the installation until it does.

Ensure the spring is correctly placed under the hole in the closer arm. It should be pinned in place securely. If not, you may need to adjust the bracket's position.

Adjusting the Closer for Proper Operation

Test the door operation to ensure the closer is working correctly. If the door isn't opening and closing smoothly, you may need to adjust the closer's tension. Most Larson storm door closers have an adjustment screw on the side of the closer.

AD

Use a Phillips screwdriver to turn the screw clockwise to increase tension and counterclockwise to decrease tension. Test the door frequently during adjustments until it operates smoothly.

Installing a Larson storm door closer can significantly enhance your door's functionality and security.

AD